System Limitations
TALS Automatic Abort (Airspeed)
Airspeed >78 kias or <50-53 kias (profile dependent for 2 seconds)
1. Altitude Level
2. Airspeed Set 70kts
3. Heading RTB
These are the steps for what EP?
Propulsion System Failure Warning (Red)
What does IFRF stand for?
Individual Flight Record Folder
What are the hourly requirements for for an RL1 Operator?
12 Live (4 AO 4 PO)
24 Sim (8 AO 8 PO)
What is the maximum data link range for the UGDT?
125 km
Landing Tailwind Component (Max)
5 kts at Surface Prior to DP
What are the EP steps for AV Failure to Climb/Descend (ASAM 19-02)?
1. General Data GUI- Open
2. Baroswitchover Mode Select- Automatic
3. Baroswitchover Mode Select- Manual
4. Command Climb/Descend- Verify AV Response
5. Baroswitchover Mode Select- Automatic if Desired
15 months
What are the VFR minimums for Class E below 10,000 ft MSL?
3SM
500 ft below
1000 ft above
2000 ft horizontally
The aircraft maximum weight is determined by the ___________________.
Launcher Precharge Pressure Chart
What are the warm up RPM’s and RAT FOR 1102 and FAFS
1102: 4500 RPM & 80°c
FAFS: 4500 RPM & 64°c
After your CHT reaches 260°c or above, what temperature must it return to?
220°c
When is an operator considered incurrent?
To be considered current, a UAC must, every 60 days, perform a takeoff and landing while operating (A seat) the UAS or an approved simulator and every 120 consecutive days, perform a takeoff and landing while operating (A seat) the UAS. The UAC whose currency has lapsed must complete a proficiency flight evaluation according to paragraph 9-59 of this TC. Simulators may not be used to reestablish currency.,aUACmust,every60days,performatakeoffandlanding while operating (A seat) the UAS or an approved simulator and every 120 consecutive days, perform a takeoff and landing while operating (A seat) the UAS. The UAC whose currency has lapsed must complete a proficiency flight evaluation according to paragraph 9-59 of this TC. Simulators may not be used to reestablish currency.
In what amount of time must the aircraft land prior to forecasted weather?
One Hour
What are the two TALS subsystems and what are all the components?
TALS AS: TALS AS omni antenna, TALS AS directional antenna, TALS AS transponder
TALS TS: pedestal, radome, interrogator, track control unit, and ruggedized serial to fiber
What are the levels of icing and the levels of turbulence we are prohibited to fly in?
Icing- Moderate to Severe
Turbulence- Severe to Extreme
While experiencing the emergency Stuck Throttle (High Revolutions Per Minute (RPM)) it may be necessary for the Aircraft Operator to ____________.
Kill the engine prior to deploying the FTS
45 days
After failing to need an ATP requirement, how long does the commander have to complete his investigation to determine the next course of action?
14 days from the date of notification
What distance apart must two UGDT’s be emplaced?
49 feet/ 15 meters
What is the Aircraft Bus Volatge Battery Failure System Limitation + What is the possible repercussion of letting your battery drop below the limitation?
<19V or <20 minutes battery life remaining
+
When the battery drops below 19V or <20 minutes battery life remaining the FTS may not deploy
You are on initial climb in the Nijmegen ROZ and reach 1500 ft MSL your CHT reaches 255°c and continues to climb and your RPMs are at 3640 RPM and slowly continue to drop to 0 RPM. This is indicative of what EP and what is the proper steps in the correct order?
Engine Failure Below 2000 ft AGL
1. Safe Heading- Establish
2. FTS- Deploy
What are the yearly requirements for an RL1 operator?
-Live and Sim hour requirements
-ACT
-AMS Training
-AMS Evaluation
-GT III
-GT VI
-GT IX
-GT XII
-ROC-V
-CBRN
-Written Exam
-No Notice
-SFE
-Upslip
Name three of the five time an aircraft must be reweighed?
1. Overhauled or major airframes hauls
2. Modification of AV weight more than 5%
3. Modification or component replacement that alters the center of balance
4. Records suspected to have an error
5. After 36 months since the previous weighing
Which one of the following are NOT one the six measurements for the TALS Set up and Survey and what is the correct measurement required?
1. TALS Location
2. TALS Height
3. Runway Slope
4. Runway Heading
5. AG Right
6. AG Left