What that Test do
What does PVT35 test?
LO frequency and dither
What component monitors the low band RF at the xmit antennas in order to isolate xmit faults
RF Detect Board
Which software on the ASE is used for PATEC?
SECAL
Which CCA monitors pod voltages?
PSP 20
Pod IPB
12P3-2ALQ184-82-84
What does T4 test?
Signals between the pod and the C9492 (encoder/decoder)
What component provides final beamport selection?
2x8 Switch
What PATEC component generates signals in order to test the ASE O-scope?
O-Scope calibrator
Which TG CCAs control your M/H dual mods and fast switches
SWGs (TG 21, 22, 24-29)
Troubleshooting for the pod
12P3-2ALQ184-82-2-1
What does F22 test?
Dual mod isolation
What component balances your LB input signals (makes the Antenna inputs the same power level), and combines the 2 inputs into 1 output
Input combiner
Which color text indicates a PATEC component?
Purple
Which TG CCA controls your set-on and KO loop switch?
TG 8
Station O&M Procedures
33D7-13-89-1
What component does T24 test?
AGO Attenuators
What component does AGO attenuation in Low band?
LB Dual Mods
What does the PATEC acronym stand for?
Portable Automated Test Equipment Calibrator
What TG CCAs provide control voltages to the VCO
Noise Controllers TG 3-6
Cradle TO
35D3-1-301
What component does T14 test?
Log CCAs
What component detects which subband an input signal is?
Linear CCAs
What TO covers PATEC?
33K9-4-26-1
Which PSP CCA controls parallel communication? It controls communication between the PSP cards and the MLV, VCO, TG, and RWR
PSP 27
Safety Wiring TO
00-25-234
1-1A-14