What is 2 percent
This an an alternator stator is excited
What is by applying voltage to the field windings
This would be the voltage of an alternator with an open field circuit
What is 0
This may cause damage to the alternator diodes
What is connecting the battery leads backwards?
This type of bearing is used in the slip-ring end housing of an alternator
What is needle/roller bearing
Upper voltage regulator points that are open will cause
What is high voltage
This is where the voltage is generated in an alternator
What is the stator
this would be the result if a 14 volt alternator's direction of rotation was reversed?
This is regulated in a generator to control its voltage output?
What is the strength of the field?
This is how current flows through a battery
What is from negative to positive?
This is the type of rectifier on an alternator
What is solid state full wave?
This smooths out the pulsations in the voltage produced in the alternator
What is capacitor?
This is the type of bearing used in the drive end of an alternator
What is ball bearing?
The field induces voltage into this part of the alternator
What is stator?
This type of winding in an alternator gives you a current advantage
What is delta?
This prevents battery current from flowing in the field circuit when the system is secured.
What is the field relay?
This prevents voltage from dropping to zero when the lower VR points are open?
What is the field resistor?
Alternator diodes do not perform this function
What is current limiting?
This is the purpose of the slip rings
What is to transfer power to the rotor?
The diodes take the place of these components of a generator
What is commutator and brushes?
The field gets is current when the voltage regulator points are open through the
What is the field resistor?
This type of current is found in the vibrating points of an alternator voltage regulator that uses transistors for voltage control.
What is transistor base current?
This is how many degrees the windings are electrically apart in an alternator
What is 120 degrees
This is why an RCCR is not required in an alternator
What is the diodes prevent reverse current
This is the correct test procedure if the alternator has zero output voltage
What is jump pin F to pin 2 or 3?