Misc
Which two pieces of information can you determine from the output of the show ntp status command?
What are the configured NTP servers and whether the clock is synchronized?
An engineer configured an OSPF neighbor as a designated router. Which state verifies the designated router is in the proper mode?
What is full?
A network administrator enabled port security on a switch interface connected to a printer. What is the next configuration action in order to allow the port to learn the MAC address of the printer and insert it into the table automatically?
What is enable sticky MAC addressing?
Which configuration management mechanism uses TCP port 22 by default when communicating with managed nodes?
What is Ansible?
Which command can you enter to determine the addresses that have been assigned on a DHCP Server?
What is Show ip DHCP binding?
What is the purpose of traffic shaping?
What is to limit the bandwidth that a flow can use?
A user configured OSPF in a single area between two routers. A serial interface connecting R1 and R2 is running encapsulation PPP. By default, which OSPF network type is seen on this interface when the user types show ip ospf interface on R1 or R2?
What is point-to-point?
What effect does the aaa new-model configuration command have?
What is it enables AAA services on the device?
What automation program uses Ruby?
What is Chef?
Which command can you enter to allow Telnet to be supported in addition to SSH?
What is transport input telnet ssh?
When configuring a WLAN with WPA2 PSK in the Cisco Wireless LAN Controller GUI, which two formats are available to select?
What are ASCII and hexadecimal?
What is the effect when loopback interfaces and the configured router ID are absent during the OSPF Process configuration?
What is the highest up/up physical interface IP address is selected as the router ID?
Which technology must be implemented to configure network device monitoring with the highest security?
What is SNMPv3?
What automation program has fundamental configuration elements that are stored in a manifest?
What is Puppet?
Which command is used to verify the DHCP relay agent address that has been set up on your Cisco IOS router?
What is show ip interface?
What mechanism carries multicast traffic between remote sites and supports encryption?
What is GRE over IPsec?
What software-defined architecture plane assists network devices with making packet-forwarding decisions by providing Layer 2 reachability and Layer 3 routing information?
What is control plane?
What are two recommendations for protecting network ports from being exploited when located in an office space outside of an IT closet?
What are implement port-based authentication and shut down unused ports?
Which JSON data type is an unordered set of attribute-value pairs?
What is object?
A network administrator enters the following command on a router: logging trap 3. What are three message types that will be sent to the Syslog server?
What is emergency, critical, and error?
Which two QoS tools provide congestion management?
What are CBWFQ and PQ?
What benefit does controller-based networking provide versus traditional networking?
What is it allows configuration and monitoring of the network from one centralized point?
A port security violation has occurred on a switch port due to the maximum MAC address count being exceeded. Which command must be configured to increment the security-violation count and forward an SNMP trap?
What is switchport port-security violation restrict?
What automation program has the following descriptions?
1. uses SSH for remote device communication
2. uses YAML for fundamental configuration elements
What is ansible?
Which command must be entered when a device is configured as an NTP server?
What is ntp master?