Fall Protection
The height at which fall protection is required in construction
What is 6 Feet
What is the amount of weight an anchor point must support?
What is 5000 lbs.
This requires inspection before and after each use.
What is full body harness and connecting device (lanyard/retractable).
Fall Clearance measured in Feet when using a full-body harness and shock-absorbing lanyard.
What is 18 to 19 Feet.
Work area designated and clearly marked in which certain types of work may take place without the use of conventional fall protection systems.
What is a Controlled Access Zone.
The height at which fall protection is required in general industry
What is 4 Feet.
Type of anchor commonly used on steel structures.
What is a beam clamp.
This is the proper location of an employees back D-ring when wearing a full-body harness.
What is the center of back between shoulder blades.
OSHA height requirement of top rail for a guardrail system.
What is 42" +/- 3"
This consists of ropes, wires, tapes or equivalent materials and supporting stanchions.
What are Control Lines.
Any hole greater than _______" must be covered.
What is 2".
The location in which an anchor point should be attached.
Responsible for purchase of full-body harness if workers are exposed to unprotected edges/ surfaces.
Who is the Employer.
This is the toe board height requirement (measured in inches)
What is 4".
Control lines must be rigged and supported so that the lowest point (including sag) is not less than _________" from the walking/working surface.
What is 39".
This is the maximum arresting force when a worker wears a harness
What is 1,800 lbs.
Number of people permitted to use an anchor point.
What is one.
Personal protective body wear consisting of straps worn around the shoulders, thighs, buttocks and hips.
According to OSHA, all scaffold workers must have fall protection when working ______ ft. or greater above a lower level.
What is 10 ft.
Control lines must be strong enough to sustain a lateral force of how much weight?
What is 200 lbs.
A ladder or steps are required when there is a ______" break in elevation.
This refers specifically to the point at which an anchoring device is affixed, fastened, tied or otherwise connected to a support location.
A type of deceleration device that allows freedom of movement with an automatic braking system to limit free fall distance.
What is a self-retracting lifeline.
Height at which fall protection is required when working from a scaffold?
What is 10 ft.
When control lines are used, they should be erected not less than ______ ' or more than ______' from the unprotected or leading edge.
What is 6' or more than 25'.