Abatement Full
What are 3 specialty heads and what is special with them?
Sure
What 3 values do you watch while doing RO
RO, Backpressure gauge, fuel flow
Why do you take the N2 off of any IXH pumps?
2 ways to purge an iAtlas
System purge and the other way
Does anyone play league of legends? I need one more competent person for a clash team
Slide into my DM's if you do
What is a dead give away that an abatement is probably a 2.1, 2.6, or 2.7?
CDA on the D port. HAS to be the D port
What are the 3 ways to adjust RO
Throttle control valve, Needle valve on premix fan, premix fan speed on HMI
If a pump does not have 50 if stop, how do you put the 50 if stop on it?
N2 regulator one time adjustment, and the config
Why do you wait before disconnecting all facilities
To wait for the pump to cool down
Whats the best nascar racer?
Dale Earnhardt, do it for dale boi
On RO with a head that has a capped inlet, what are you supposed to do with the injects and why?
Remove them because they are N2 high pressure purges and are flowing N2
Name 5 interlocks, what alarms they send out and where to find them
:D
If your gate valve is greyed out after a pump exchange on the HMI, and it is unresponsive, what do you need to do?
Cycle gate valve with PDT
What are the 8 loto points on an iatlas
N2, O2, CDA, NG, bypass manual iso, water drain, tape over the green button, power
Whats the best fruit?
Pomegrante
What would you check if your abatement didnt want to light after a PM? 3 major things
Screw inside ignitor caps, Ignitor, Pilot gas
On a etch head crowned system that has bypasses on 2 and 5, and crowns on 1,2,3, and 4,5,6, what buttons do you press while doing injects for inlet 6?
Pump run 5, clean 5
Describe how to do a full leak check on a brand new bypass thats already installed
O.o
What do you make sure the pump doesnt have before pressure leak checking to the abatement, to prevent an overpressure event.
The pump N2 dilution (pump purge)
Best holiday?
Halloween
What and specifically where would you check if you had an abatement went down for high ADT temperature?
Around heat exchanger or the iso valves for PCW
Assuming theres no leaks, what are some major ways N2 or extra oxygen can get into the system? (at least 3)
bypass, purges, atomizer
What do you leave disconnected until as late as possible on a pump and why?
The ethernet, because similar IP's could bring down a live pump
What are 3 different measurements for vacuum?
Torr, Inches of mercury, inches of water, pascal
Worst alcoholic drink?
White claw/seltzer. Lemon White claws taste like someone waved a lemon on top of the white claw and that was almost too much flavor