Enter Title

Test 1

100

A ball shaped disc with a hole through it is what type of valve

Ball valve

200

A pipe with several opening for making multiple connections is?

Manifold

300

This type of purge requires pressurizing the vessel and venting 3 times

Pressure

400

A metal cage that sits on the end of the vacuum leg that can have a cotton or dacron cloth on it

Dryer sock cage

500

This is placed over the nutsche boards, is made from plastic with large opening holes

Vexar Screen

Test 2

100

Which piece of equipment has the highest estimated flow to the RTO?

Nutsches

200

This procedure states specific step-by-step rules for operating the equipment located in the manufacturing area

EOP

300

This piece of equipment is suspended from the ceiling on the load cells

Weigh Tank

400

What does VOC stand for?

Volatile Organic Compound

500

What line is used to heat the tempered water for circulation through the jacket?

Jacketed Pipe

Test 3

100

What precent caustic is used in caustic scrubbers?

20%

200

What system do we have that when used will block the flow of material being transferred into the building in case of a leak, fire or other emergency condition?

Emergency Cut-off valve

300

What is the 2nd stage of a two-stage scrubber system?

Caustic Scrubber

400

This is located inside the dryer and has a sock cage on the end of it and is connected to a vacuum source 

Vacuum Leg

500

What are the two most important parts of the steam ejector?

Nozzle and Venturi

Test 4

100

This type of valve will allow fluid to flow in only one direction

Check valve

200

This switch is located in the bottom of the nutsche and prevents the occurrence of "monkey Pumping"

High Level Sensor

300

A safety mechanism that consist of a series of locks that must be operated that prevents entry in the dryer cage while the dryer is rotating

Kirk-Key Interlock

400

This equipment is used to remove volatile from the solid material by evaporating the more volatile material away

Dryer

500

Where is the cloth located on a centrifuge

Behind the screen

Test 5

100

The purpose of this piece of equipment is to add a liquid or solution to a reactor at a specific rate

Weight Tank

200

Why is make-up water added to a scrubber system?

A. To flush the scrubber out

B. To maintain an overflow

C. To knock down more impurities

B. To maintain an overflow

300

Name 2 things to check if the dryer will not pass the leak check

The gasket, dropout valve open, etc.

400

What is the largest source of air flow going to the RTO

Nutsches

500

What is the difference between a single stage and three stage jet system?

Amount of ejectors and condensers