OSHA 10 HR 1
Spoil piles and/or equipment must be kept at least _____ feet back from the edge of the excavation.
What is 2 feet.
A technique that focuses on job tasks as a way to identify and correct hazards is also known as:
What is a "Job ____ _____"
What is a Job Hazard Analysis
Equipment such as forklifts, backhoes and scaffolding must maintain at least a ____ foot minimum clearance from overhead power lines.
10 ft
True or false - According to OSHA Table 1 for Crystalline Silica, is a respirator required when using handheld power saw outdoors for more than 4 hours in a day?
TRUE
"Electrocution” means ___.
Killed by electrical shock.
OSHA inspections are ____________ conducted without advanced notice.
Almost Always
90 percent of incidents are a result of ________?
Human behaviors
A stairway, ladder, ramp or other means of egress must be located in trench excavations that are____ feet or more in depth.
4 ft
Fill in the blank - Our company policy states that work will stop when air temperature’s reach ___ or if the heat index is ___ or greater.
100 degrees Fahrenheit - 103 degrees Fahrenheit
What does GFCI stand for?
Ground Fault Circuit Interrupter
In construction work, fall protection is needed at how many feet above a lower level?
What is 6 feet
In a personal fall arrest system, anchor points must have a minimum breaking strength of:
5,000 lbs
How often should vehicles being used at worksites be inspected?
Daily, or at the beginning of each shift
When digging around a utility at what distance must you hand dig until the utility is exposed?
18 inches
ZTI= 36 inches
Michigan= 24 inches
Complete this statement when it comes to our company safety policy.
“Safety is a ____“
Value
Employers are required to post the OSHA Job Safety and Health-It's The Law poster in your workplace. True or False?
True
If you have questions about fall protection or any other safety concerns, who should you ask?
Your Supervisor
What is the most significant hazard facing workers in a trench?
Cave-ins
OSHA's mission is to:
A. Protect the workers of the general public.
B. Ensure all workers receive minimum wage.
C. Protect the safety and health of American Workers.
C: Protect the safety and health of America's workers.
What is the most common type of work zone collision?
Rear-end-collision
The most common cause of fatalities in construction.
What are falls
What procedure is used to prevent electrical injuries when there is potential for unexpected energization of equipment that could cause harm to an employee?
What is lockout/ tagout
Excavations over 6 feet deep and not obviously visible must be, at minimum:
Barricaded or marked.
What type of OSHA inspection is conducted when immediate death or serious harm is likely?
Imminent danger
These items are the minimum requirements for flaggers PPE:
Class 2 vest and Class E pants.