Valve Adjustment
What is the name of the tool used to measure valve clearance?
Feeler Guage
What will happen if there is too much Valve clearance?
The engine will be loud and will lead to valvetrain failure
Before removing any internal engine component what should be done?
Must be marked and indexed
Its used to hit things
Hammer
Why is it bad to have a lockdown Wednesday morning? While sitting in CLOSE Proximity
Doms Taco Tuesday
What two wrenches are needed to adjust the valves?
10 and 14 MM
How do you confirm the Piston is at BDC?
Using a screwdriver through the sark plug port
What can be done to every fastener (Nuts and Bolts) on an Engine?
A Torque procedure
It is the middle size screwdriver
Number 2
What is the valve clearance you need for the intake and exhaust
.006 and .008
What direction do you rotate the crankshaft when performing a valve adjustment?
Clockwise
When adjusting valves what is the 10MM nut called?
Jamb nut
What procedure should you do when installing a Camshaft?
Align camshaft and the crankshaft
It has an open end and a box end
Combination wrench
What's Mr. WetLicks Favorite Pizza
Spinach Pizza and sauce
What will happen if there is too little valve clearance?
The engine will run poorly and lead to Valve failure
What are Two reasons for Adjusting valves?
After Engine disassembly and as regular preventative maintenance
What procedure would you perform to determine crank journal to connecting rod oil clearance?
Plastigage
It is the smallest ratchet size
Quarter inch
What's the small little part that goes on top of the exhaust valve
The Rotator Cap
Between what two engine parts is the valve clearance measured?
Between the rocker arm and the valve
How do you verify the engine is in the correct position to adjust the valves?
Piston is at TDC and both valves are closed
What procedure should you perform to determine how healthy an engine is?
Cranking compression test
It is used when installing a piston
Ring compressor and Hammer
What would you do if you walked into a room and there's a potato with metal electrodes on the side of it
Hold it till it zaps you