scroll saw
ban saw
sand tester
miter saw
random safety
100
Never put your fingers in line with the blade?a critical safety rule to prevent serious cuts
yes
100
The best time to remove scrap material from the band saw is ___________.
when the saw stops
100
what is number 2 
abrasive belt
100
How must the saw blade be held after the cut is finished and before the blade stops rotating?
Hold it in the down position
100
what do not do in a wood work shop
goofing around,not paying attention etc
200
If you push too hard what will happen?
The blade will break
200
Which of the following is the correct procedure to determine if the blade is operating on the middle of the band saw wheel?
Turn the wheel by hand to check
200
what is number 5
abrasive disc
200
How can the saw operator prevent the blade form binding when cutting warped, bowed, or long stock?
Clamp the stock to the table
200
what to do when a machine isn't working properly
turn it off and notify the teacher or instructor the notify
300
Always leave the saw with the light off and the speed all the way down
yes
300
If too much cutting pressure has to be applied to make a cut, the blade __________.
is dull
300
what is number 3
disc table
300
When is it safe to remove wood scraps from the cutting zone?
While the saw is off and the hand is not on the On/Off trigger
300
what to do when you get cut in the shop
notify the instructor
400
If the blade breaks:
unplug and notify the instructor
400
It is safe to place the hand in line with the blade of the band saw __________.
only when the machine is not operating (i.e. during setup)
400
what is number 4
belt table
400
The purpose of a trial cut before making the actual cut with the motorized miter saw is to ____________
see if the saw is cutting properly and is set accurately
500
what to do when you cutting wood?
hold your wood down foot
500
The danger zone for the band saw (where you should not stand in case the blade breaks) is:
to the right of the operator's position (next to the band saw table)
500
Keep hands and fingers at least _____________________ inches from all moving parts on any machine.
4 inch
500
How should the saw blade be moved throughout the stock when making a cut with a motorized miter saw?
a safe speed that will not burn or splinter