PSMS
P_ _ _ _ _ _ _ L
Safety
Managment
S_ _ _ _ _ M
Personnel
System
PSMS is required for all tasks?
False
PSMS is for task with Fatality / Life Altering Injury Potential or task involving LSRA's PSMS
Job Safety Analysis (JSA) is being used to address life-altering injury related details beyond those covered by applicable LSRA SWCs (not duplicating SWCs) or when an SWC is not applicable
Where are the additional hazards noted when discussed in a Pre Task Brief?
Bonus question for 500 What should be documented on the back of the PSMS JSA?
On the back of the PSMS JSA
Hold Points
Who has to be present during all Pre Task Brief?
OS, Rig Manager, SSHE Coach, PSMS Trained Delegate
How many months have 28 days?
All of them
Start work checks "shall" be performed when?
During the Pre Task Brief with the work team immediately before starting work.
At hold points during the task to confirm safeguards are in place and effective.
Upon identifying a trigger when work conditions, scope, or task hazards change.
All tasks perform have Hold Points?
False
Not all tasks have Hold Points
What is the second topic in the LMRA?
Think
Name some LSRA's that are rarely discussed or used?
Excavating, Breaking Containment, Bypassing Safety Controls.
You have one match and enter a dark room containing a candle, fireplace, and lantern. What do you light first?
The match
I am a Pre Task briefing tool...what am I?
JSA
Following any Non-Routine Tasks an AAR (After Action Review) should be performed?
True
What does the green box in the flow chart cover?
LMRA Go to Work
What is required for all repetitive tasks?
How many Presidents were named James?
6-
James Madison, James Monroe, James Polk, James Buchanan. James Garfield, James Carter
What are the three interrupters' in PSMS?
There's not three, there's two
Hold Points & Triggers
The objective of PSMS is to eliminate Fatalities / Life Altering Injuries (LAI)?
True
What is the definition of a "Trigger?"
Correct answer only!!
Provides a clue that a hazard may be present or a safeguard may be absent and the team should stop work and address the condition or behavior.
If you found a piece of equipment with an unapproved device on it to make your work easier which LSRA would you be violating?
Example: Putting tape or zip tie around a fuel nozzle.
Bypassing safety controls
If you are facing East and the wind is blowing from the South at 30 mph and you turn 180 degrees where is the sun positioned?
Still East
What is the third question in the AAR?
Describe what were the differences.
Work can be performed without safeguard verification.
Bonus for an additional 500 points: Besides yourself when you are conducting your Last-Minute Risk Assessment (LMRA) Who is required to verify all safeguard verifications?
False
OS, SSHE Coach, Rig Manager, PSMS Trained delegate
How many bullet topics are listed under Work Environment "Error Prone Situations"?
5
*Work area difficult to access *Work arounds
*Confusing displays *Change from routine
*Inoperable equipment
What is the purpose of a "Hold Point"
I don't want the definition I want you to tell me the purpose of a "Hold Point"
Planned times to determine safeguards are in place.
Hold points and pre task briefings are not the same.
It's not only this team's logo but it's also their rating?
1 star
Dallas Cowboys