Area Monitoring
Personal Monitoring
ALI & DAC
Screening
I'm Feelin' Lucky
100

When we have a posted ARA, we are required to monitor this location. Periodt.

ARA Boundary

100

Which air sampler do we use to perform personal monitoring?

BZ

100

___ is the amount of a radionuclide that if inhaled or ingested would irradiate a person to their limiting value for control of occupational exposure. 

Annual Limit on Intake (ALI)

100

Which side of the filter paper do you screen?

The side that is marked (inlet side)

100
What does IDLH stand for?

Immediately Dangerous to Life and Health

200

This type of monitoring is often performed at or near the source.

Work Area (Inside Area)

200

If more than one person will be assigned to the PAM, which worker should wear it?

The worker expected to have the highest potential intake (based on the work activity).
200

___ is the concentration of a radionuclide in air that if inhaled or ingested would irradiate a person to their limiting value for control of occupational exposure.

Derived Air Concentration (DAC)

200

When screening the Work Area lo-vol filter paper in a posted ARA during job coverage, compare the results to the _______ ________ and to the MUC of the required respiratory protection. 

Limiting Condition

200

Thin amounts of almost any material can shield this type of radiation (paper, unbroken dead cell layer of skin, a few cm of air).

Alpha

300

If no airborne data exists for a job, we perform this type of sampling beforehand. 

Baseline or characterization

300

What is the primary function of a BZ?

To characterize personnel exposure 

300

What is the Fed Ted?

5 rem

300

Which type of radiation is not normally screened for air sample concentration, but must be considered when determining if an air sample is to be handled as RAM?

Beta

300

Because Uranium has a PEL of 0.05 mg/m3, which is the chemical concentration at which we must begin to use respiratory protection, we post an ARA at __% of the alpha DAC Value?

10(%)

400

An average of the area monitoring samples for a given job will be used to determine which Radiological Requirement listed on the RWP?

Bioassay Mode

400

BZs must be screened for a __ DAC-hr threshold. 

4 (DAC-hr threshold)

400

Our PORTS alpha DAC Value is configured for which radionuclide(s)?

The Uraniums--234, 235, 238

400

Meter ___ is not considered for screening, only for field counting

MDA

400

If you were to stand in an area and breathe air that is at 1 DAC of any radionuclide for a working year, how much total exposure would you receive?

5 rem

500

This type of air monitoring is performed to provide surveillance of low concentrations of airborne radioactivity in various facilities.

Routine

500

If a BZ or BZs are used for personal monitoring for a job, what will the Bioassay Mode on the RWP be?

DAC-hr Tracking

500

Which physical control used at PORTS is built upon DAC values?

ARA Posting Limits

500

RP-PRO-00009 Appendix C is intended to help RCTs analyze air sample concentration using the instrument's run time and activity to determine what?

DAC

500

Which two RP programs complement one another to help us determine or verify personnel exposure at PORTS?

The Internal Dosimetry Program & the Air Monitoring Program