What is the first step of the EDP?
This tool is used to drive nails into wood.
What is a hammer?
These should always be worn to protect your eyes in the workshop.
What are safety glasses?
This measuring tool is commonly used to measure wood pieces.
What is a tape measure or ruler?
This dimension should be set as your default.
What is inches?
This step involves testing the prototype to see if it meets the design criteria.
What is Test?
This tool is used to make cuts in wood using a motorized blade.
What is the scroll saw?
If your hair is past your chin what do you need to do?
This measuring tool is used to make 90 degree angles.
What is a square?
This is the first step to creating anything in Fusion.
What is Create Sketch?
Engineers brainstorm and create drawings in this step.
What is Develop Possible Solutions?
This tool is used to smooth rough surfaces and edges of wood.
What is sandpaper?
This safety device removes dust and wood particles from the air.
What is duct collector?
The small lines between whole numbers on a ruler represent what?
This takes something from 2D to 3D.
What is extrude?
Before building a final product, engineers create this smaller version to test their ideas.
What is a prototype?
A drill bit for making large, clean holes. HINT: It is NOT self cleaning.
What is a forstner bit?
When putting material back into the scrap bin what should you do?
When measuring something what line or number should the end of the object be on?
What is 0?
What tab do I open to access my past projects?
What is the home tab?
When an engineer improves a design based on testing, what step are they in?
What is improve?
This tool holds wood in place while cutting, drill, or assembling.
What is a clamp?
When cutting wood close to the blade what tool should you use to push the wood?
What is a push stick?
What tool should you use when measuring something over 12 inches?
I do this to edit a past sketch or extrusion.