Show:
General
Bandsaw
Mitresaw
Disc Sander
Drill Press
100

You need to wear these at all times in the woodshop.

What is safety glasses?

100

The purpose of the blue button

What is turn the bandsaw on?

100

You change the angle of the saws cut by doing this.

What is pushing the lever and swiveling/turning the table of the machine?

100

You should mainly use this part of the sander.

A) Disc

B) Belt

What is A) Disc?

100

This is the purpose the drill press

What is to drill holes?
200

You need to make sure these things are out of the way, on your person, when working in the shop. Must give 2.

What is hair, flowy clothing, or bracelets?

200

The only time you leave the bandsaw running.

What is there is someone ready in line behind you?

200
You set the saw to this degree to cut a right angle.

What is 0 degrees?

200
When using the disc sander you use this side of the circle sandpaper.

What is the left side OR the downward spinning side?

200
We commonly use this bit to drill smaller holes and it is self cleaning.

What is a spiral bit?

300
This rule applies in both the classroom and woodshop.

What is no touching?

300

You need to use this tool when make smaller cuts.

What is the push stick?

300

You only cut this direction on the board. 

HINT: Deals with the grain.

What is across the grain?

300

You must turn this on before using the sander.

What is the dust collection?

300

We use this bit when we are drilling larger holes. This bit is NOT self cleaning so we must clean it while we drill.

What is a forstner bit?

400

We do not run in the shop because of this effect.

What is slipping and falling?

400

This happens when you twist the blade too much or back out of a long cut.

What is the blade falls off its track?
400
When lining up your cut you place the blade on 

A) the side you want to keep 

B) the side you do NOT need

What is the B) the side you do NOT need?

400

This tool helps you sand accurate angles on the disc sander.

What is the fence?

400

When drilling a small piece you use this tool to hold your piece.

What is a vice?

500

We practice all safety rules for this reason.

What is to keep ourselves safe and to keep others safe?

500

The reason it is called the band saw.

What is the saw is a big loop/band?

500

The piece you are cutting on the mitre saw has to have this much length to hold onto while you cut.

What is 5 inches?

500

This is the reason we do NOT sand small pieces.

What is the piece will get sucked down and pull your fingers into the machine?

500

RPM stands for this and means this.

What is rotations per minute and how many times the drill bit goes around in one minute?