Basic Eletrical Fundamentals
Tools & Diagnostics
Automotive Eletrical Systems
Wiring, Circuts & Componets
Troubleshooting Scenarios
100

The flow of electrical current through a circuit is called this.

What is current?

100

The number one tool used to test voltage, resistance, and continuity.

What is a multimeter?

100

The component that starts the electrical system when the key is turned

What is the battery?

100

This protects a circuit from too much current.

What is a fuse?

100

The starter only clicks once. Battery is good. What should you check next?

What is voltage drop on the starter’s positive and ground circuits?

200

The force that pushes electrons through a circuit.

What is voltage?

200

This tool is used to safely check for unwanted current draw when the vehicle is off.

What is an ammeter or parasitic draw tester?

200

This component charges the battery while the engine runs.

What is the alternator?

200

A device used to open or close a circuit using a small electrical signal.

What is a relay?

200

A blower motor works on high speed only. This usually indicates what failed component?

What is the blower motor resistor?

300

This measurement represents resistance in a circuit.

What are ohms?

300

Before using a scan tool, you must always check this basic thing first.

What is battery voltage?

300

These two types of sensors are the most common in modern vehicles.

What are voltage (DC) sensors and resistance-based sensors?

300

Before unplugging any connector, you should make sure of this

What is the ignition is off?

300

Brake lights stay on even when the vehicle is off. What is the most common cause?

What is a faulty brake pedal switch?

400

In a series circuit, if one component fails, this happens to the entire circuit.

What is the whole circuit stops working?

400

This tool sends power to a component to see if it works without using the vehicle’s wiring.

What is a power probe?

400

This system uses fuses, relays, and modules to control how power is distributed.

What is the power distribution system?

400

These charts help you trace wiring paths and locate power, grounds, and splices.

What are wiring diagrams?

400

After repairing wiring, several modules won’t communicate. What must be inspected?

What is CAN wiring polarity, continuity, and resistance?

500

This law states that V = I × R.

What is Ohm’s Law?

500

This setting on a digital multimeter should be used to test if a wire is connected from end to end.

What is continuity mode?

500

These computers control everything from engine timing to communication between modules.

What are ECUs or control modules?

500

This type of circuit has more than one path for current to travel.

What is a parallel circuit?

500

A customer reports the battery dies overnight. You find a parasitic draw that disappears when a specific fuse is removed. What does this tell you?

What is the fault is in the circuit powered by that fuse?