What Do You Do
This provides maximum safety, ensures you don't forget any steps, ensures others know there is a hazard, ensures everyone is paying attention to any work hazards present.
Procedures to be followed in the workshop.
One time fastener
Wall anchor
It's used to fasten a pipe strap to a cement wall.
Masonry nail
It allows easier access to nuts and bolts in tight locations and they have multiple interchangeable pieces to accommodate sizes of nuts and bolts
Socket Set
Represents a different temperature
15°C / 475°K / 59°F / 519°R
475°K
At no time is this allowed in the workshop.
Eating (Eating is not allowed in the workshop)
Pop Rivet
Blind rivet
It is measured in circular mills.
Copper wire sizes
Air conditioning and refrigeration reversible ratchets are used to.....
Open and close refrigerant service valves
A description of the level of heat.
Heat
There is no designated place for this in the workshop.
Sitting (You are not allowed to eat anywhere in the workshop)
Must be installed in a properly sized pre-drilled hole.
Pin rivet
It fastens a duct hanger strap to a floor joist.
Roofing nail
Its not the square type of screwdriver used to tighten and loosen set screws.
Torx type
Where all molecular biology activity stops.
-460°F
Allowed to make safety corrections in the workshop.
Everyone (is allowed to make safety corrections in the workshop.)
It can not be connected as a full wave rectifier.
Single Diode
Pin or bind rivets are assembled on this type of pin.
Mandrel
It can be programmed to automatically charge or recover refrigerant.
A programmable charging scale.
Celsius scale where all molecular activity stops.
-273°C
Safety glasses, Uniform, Close toe shoes
What to have on in the workshop.
When checking this with an ohmmeter and the meter shows a resistance, if the meter leads are reversed, it should show infinity.
Diode
Hole drilled in sheet metal for tapping screw should be.
Thread root diameter
It can be used for holes as well as tighten and loosen screws
Variable speed reversible (electric drills)
As temperature of a material increases, the molecules in the material...
Travel faster