tire and wheel
what is the limit of a slip mark?
1/4 inch
can you run a 0 on a patch test?
no
what procedure do you perform before turning on hyds after doing flight control maintenance?
boost-on sas-off
what color is a rotor head servicing required?
on the line or in red
what is the repair limit of the main rotor blade root laminates?
none
what is the limit for cord showing on a tire?
what is considered a bad sample for se? what is considered a bad sample for a/c?
3 for se. 5 for ac
what blade do you take measurements off of for a main rotor rig?
red
how far into the black is the hyd pump servicing allowed to be?
3/8
what is the dent limit on the stabs that require a doubler patch?
1/4
what ply rating is used on the H60R main mount tires?
10 ply
what's the allowed operating time for a hyd pump to be running when the outside temperate is 101-125 degrees? how long is a cool down required?
16 minutes op time, 48 minute cool down
what is the spring force of the spring capsules?
200-pounds
what is the servicing limit on the ecs?
oil covering the sight glass
what is the crack limit on the titanium upper exhaust fairing?
3 inches with stop drills, after 3 inches trim away the crack and perform a doubler patch
what do you use to grease bearing with?
mil-prf-81322
what hydraulic pdi are you allowed to push in and monitor?
pam
does a pedal adjuster require an fcf?
yes
what is the pressure limit on a main rotor head accumulator at 127 to 132 degrees with a a fluid charge?
1905-1765
what is the minor damage limits of tail cone canted bulkhead hinge fittings?
nicks, scratches, or corrosion no deeper than %5 of the material thickness
what are the green circles on the outside of the h60r main mount tires?
what is the maximun torque spec for the hydraulic filter housings
95 inch pounds
when adjusting balance springs what is the minimum amount the front edge of the tie bar will be inside of the slot?
0.060
what do you use to service the shimmy damper with?
silicone fluid
what is the damage repair limit of the cabin jettison window? Romeo
5% of the material thickness