Defects
Picture 1
Tacking
I can pull and stretch with tension multipliers up to 1930mm wide
TL1
I record information about coils that we send to the customer
PQI
After removing metal from the OD, I need to apply which sample label to the lab sample
BE sample label
my inner qualities will accept almost anything, as long as my surface isn’t broken
QG-05
Picture 2
Oscillation
Many strands and the widest gauge range in our facility
SL1
- I hold all information about coils, including completed steps and ones yet to come
KPS
When completing reprocesses you must enter information into what system?
PQI
I’m mainly used for structural components, cake pans and shovels
QG-18
Video 1
Wrinkles/Creases
Caustics, lubricants and levelling are some of the things I do
CL1
This is where you find all SOP’s and metal conditions
ETQ
If not sending coil to pack, and not rewinding I should do this
RTW
I’m one of the trickiest codes, as I can be exposed, painted or un-exposed
QG-17
Picture 3
Water stain
I use extreme heat and water to temper expectations
CASH
All information regarding shipping, receiving and customer specifications are stored here
SAP
All reprocess instructions are completed, but the coil does not need to be rewound. However, it does need to be packed. What do I do now
NOP
Used in make-up containers, and architectural applications
QG-16
Picture 4
Knife mark from unpacking
Squeeze me, stretch me, shape me where am I?
CM1
I have a library of defects, that are consulted as the sheet passes by my cameras
SIS
Instructions are to remove 50m for off gauge.Before removing coil from the line, what must you do?
Verify gauge
You see me on the outside of many vehicles on the road today
QG-06