Adhesives
All ARCA accepted insulation adhesives can be used as general purpose adhesives.
What is NOT TRUE?
This technique of warming the rolls is not an acceptable technique in cooler weather.
What is warming with an open flame?
Adhesive should be kept 25mm (1") back on the side laps to accommodate this tool.
What is a hot air welder?
671 m
What is the elevation of Edmonton (above sea level)?
-18°C and a wind velocity more than 14.5 km/h, or an equivalent wind chill of -26°C.
At what air temperature at roof level should roofing application be stopped?
The temperature when asphalt transitions from a semi-solid state to a solid state shares the same number as the Edmonton Oiler who scored the first NHL goal in franchise history.
What is 4? (Kevin Lowe)
TB-2020-08
What Technical Bulletin announced the acceptance of the IKO ArmourStick system?
This application technique is NOT ACCEPTED by the ARCA for SBS cap sheets.
What is mopping / installing with hot asphalt?
The coldest temperature on record in Alberta, is the same number as this famous NASCAR driver.
Who is Jimmy Johnson? (-48)
You should be storing your TPO cut-edge sealant at this temperature.
What is +20.
These cartridges can be stored at +10 before application.
What is Soprema Duotack 365?
What is +5?
This cold applied adhesive was recently accepted as the only cold-applied SBS adhesive.
What is Soprema ColPly EF?
During a Polar Plunge, the water temperature is normally around this temperature.
What is +4?
ARCA requires EPDM cold weather application requirements be followed when the temperature falls below this prime number.
What is +5?
This adhesive can be stored with NO temperature restrictions.
What is Soprema Duotack 365?
J.F. Cote from Soprema says not to install Soprema Sopraply Stick Traffic Cap when this freezes.
What is water? (0 degrees)
For a cold applied SBS cap sheet, this application temperature is CRITICAL!
What is 0 (zero)?
This electric vehicle's range drops from 420km to 320 km when the temperature falls to -12.
What is the Ford Lightning?
At this temperature, it's time to STOP the Invisiweld application process.
What is -18?
The highest temperature this adhesive can be stored at before application - which is the same as this Germán Edmonton Oiler.
What is IKO Millenium? (+29)
Relaxing the membranes, proper primer, proper flash-off and rolling out.
What are the 4 critical aspects when installing self-adhered SBS membranes?
November 30, 2022
When was the first cold-applied SBS membrane accepted by the ARCA?
Matthew McCauley
Who was the first mayor of Edmonton?
This self-adhered application technique has NO temperature restrictions!
What is RapidLock?