Show:
Questions
Responses
Print
Friction
Juice
More Power!!
Panicking
Spin the Disc/bang that drum
100
Name the types of brake lining material
What is Organic Semi-metallic Metallic Ceramic
100
Pressure is _______ in an enclosed system.
What is equal
100
The types of boost systems used
What is Vacuum-boost Hydro-boost
100
The parking brake must be seperate from this
What is service brakes
100
Vents or fins are designed on drums/rotors to _______ _____
What is dissipate heat
200
The methods linings can be attached to the backing
What is riveted or bonded
200
The higher the DOT #, the higher the _______ point.
What is boiling
200
Name the 2 systems effected by a failure of a fluid type boost system
What is power steering & power braking
200
An AMBER illuminated light means
What is A failure has occurred in the ABS system
200
After replacing drum shoe linings, a particular adjustment must be done to ensure proper ______ ______ height is achieved.
What is brake pedal
300
A spongy brake pedal indicates?
What is bleeding is required
300
Name the 3 reasons a RED brake light would be illuminated
What is A brake pressure loss Low fluid level Park/emergency brake on
300
Name the methods a park brake can be applied
What is mechanically, or electronically
300
Sometimes _____ or _____ spots ocurr on drum/rotors surfaces that must be machined completely
What is hard or hot
400
Name the 2 types of drum brakes
What is leading/trailing, & dou-servo (self-energized)
400
Brake fluid is _________ and requires periodic __________.
What is hygroscopic, & flushing (replacing)
400
What should happen when you pump the pedal several times with the engine off, then start the engine on a power boost system that uses AIR for boost
What is the pedal should drop
400
ABS whel speed sensors produce a(n) _____ signal
What is A/C voltage
400
Disc brake rotors must be measured for _______ ______ & ____ __ ______.
What is Minimum thickness, & out of round
500
name the 3 types of caliper designs
What is fixed sliding floating
500
The DOT # specified for ABS brake systems
What is DOT 3 or higher
500
Name the 3 stages of operation
What is Released Applied Holding
500
Most Park brakes are located in the rear drums. Some can be located in the _______, or on the __________.
What is Disc brakes, driveshaft
500
A vehicle with 4 wheel disc brakes and ABS is referred to a ____ ______ system.
What is Four channel