Show:
Tire Machine
Oil Change Procedures
2 and 4 Post Lift
Tire Balancing
Review from Last Semseter
100
This portion of the tire machine consists of the parts the duck head, and the vertical slide?
What is the swing arm
100
What is the first step needed to be performed when exiting the vehicle?
What is walk around inspection
100
These are the two student positions needed to pull a vehicle on the lift
What is spotter and driver
100
Theses are the two different types of balancing methods
What is static and dynamic
100
Round hole bored (machined) in the block. It guides the piston movement.
What is a cylinder
200
This is the portion of the machine is one that rotates around.
What is the table
200
Where should you place the oil filler cap in order to not drive off without oil in it.
What is in the hood latch
200
What are the reasons for rolling down the windows
What is to hear spotter, and to not lock the keys in the car
200
what should be done after the tire stops spinning
What is line up the line to the middle with light flashing
200
Links piston to the crankshaft
What is connecting rod
300
Which direction will the table rotate if you step down on the right pedal?
What is clockwise
300
This important step must be done after the oil is drained
What is clean residual oil
300
this is used on the 4 post lift to release the safety controls
What is the red button
300
this is used to align the wheel on the shaft
What is the centering cone
300
Changes reciprocating (up and down) motion of the piston and rod into useful rotary (spinning) motion.
What is the crankshaft
400
Which direction will the table rotate if you lift up on the pedal?
What is Counter clockwise
400
this is the amount of oil that is shown on the dip stick between the hash marks
What is 1 quart
400
how many jacking points should a vehicle be lifted by
What is 4
400
this type of wheel weight has a wider gap
What is one for an aluminum wheel
400
Uses internal hydraulic system and, in most cases, electric controls to shift gears
What is an automatic transmission
500
What is the sensor called that you always want to protect when mounting and dismounting?
What is Tire pressure sensor
500
This is the easiest place to find the manufactures recommended oil capacity
What is owners manual
500
this is the first step needed to be done before lowering either hoist
What is make sure tools and materials are clear of the area
500
These are the three components used to enter the data into the machine
What is number on side wall, caliper, and arm on machine
500
A special impact wrench designed for working in limited space.
What is an air ratchet