COMMANDS
This mode restricts cursor movement to horizontal and vertical directions for drawing straight lines.
What is ORTHO mode?
This dimension type should be used instead of linear when measuring an angled object.
What is they should have used ALIGNED?
This command creates an exact duplicate of selected objects.
What is COPY?
This dimension type measures the full distance across a circle, passing through its center point.
What is DIAMETER?
This command creates parallel objects at a consistent distance from an original object.
What is OFFSET?
This command edits multiple separate lines so they behave as a single connected object.
What is PEDIT → JOIN?
This layer should be used when creating blocks so they inherit properties correctly when inserted.
What is it was not created on Layer 0?
This command creates a reversed copy of an object across a specified axis.
What is MIRROR?
This dimension type measures the true length of an object that is drawn at an angle.
What is ALIGNED?
This array type creates multiple copies of objects arranged in rows and columns.
What is RECTANGULAR ARRAY?
This method uses relative coordinates to copy an object a specific distance from its original position.
What is using relative coordinates (@10,0) with COPY?
These must be correctly selected in order for the TRIM command to remove the intended portion of an object.
What are the cutting edges?
This command changes the size of an object proportionally based on a scale factor.
What is SCALE?
This dimension command is used when you want each new dimension to start from the last extension line.
What is DIMCONTINUE?
This array type creates multiple copies of objects arranged evenly around a central point.
What is POLAR ARRAY?
This array type places copies of an object along a selected curved or linear path.
What is PATH ARRAY?
This layout setting controls how a drawing is scaled when printed.
What is the viewport scale?
This command applies the properties of one object to another object.
What is MATCHPROP?
This dimension type measures multiple distances from the same starting point instead of chaining them together.
What is BASELINE?
This command creates a rounded corner between two intersecting objects.
What is FILLET?
This tool is used to create circular shapes in isometric drawings by simulating a circle.
What is ELLIPSE → Isocircle?
This setting must be correctly selected to ensure objects snap to the intended points such as endpoints or midpoints.
What is the correct snap (like endpoint or midpoint) not being selected?
This command lengthens objects so they meet a selected boundary edge.
What is EXTEND?
This setting controls the overall appearance, scale, and units of all dimensions in a drawing.
What is DIMSTYLE?
This command creates a straight, angled edge between two intersecting objects.
What is CHAMFER?