Pipette Basics
Modes
Speeds
FINAL JEOPARDY
100

A TD pipette is calibrated to do what with its stated volume?

Deliver it

100

In which delivery mode does liquid drain under its own weight?

Gravity drain.

100

Which aspiration speed should be used for pipettes up to and including 5 mL?

LOW

200

What does TC stand for?

To Contain

200

Which delivery mode requires expelling the remaining liquid from the tip?

Blow-out.

200

What aspiration speed should you select for a 2 mL pipette?

LOW

300

What normal liquid behavior is accounted for in the calibration of a TD pipette?

A small amount of liquid normally remains on the inside wall after proper delivery.

300

When using gravity drain, what should you do with the residual liquid in the tip?

Leave it there; do not force it out.

300

What aspiration speed should you select for a 10 mL pipette?

HIGH

400

What should you consult if a pipette's markings or delivery instructions are unclear?

Manufacturer's instructions.

400

What should happen before the final expulsion when using a blow-out pipette?

Normal gravity drainage.

400

What happens when you press the aspiration trigger farther?

Liquid is drawn into the pipette faster.

500

What do TD and TC describe about a pipette?

Its calibration and intended volume relationship.

500

What can happen if you use blow-out technique on a gravity-drain pipette?

You may deliver more than the calibrated volume, resulting in inaccurate measurements.

500

Why might using a faster aspiration speed than necessary create problems when handling a small volume?

It can make liquid uptake harder to control and increase the risk of overshooting, splashing, or drawing liquid too quickly.

500

Question:

Two employees are preparing to dispense liquid using the same 10 mL Fisherbrand serological pipette. The pipette has a double band near the top indicating that it is a blow-out pipette.

  • Employee A selects HIGH aspiration speed and GRAVITY dispense.
  • Employee B selects LOW aspiration speed and BLOW-OUT dispense.

Neither employee has selected both settings correctly. Identify the correct settings and explain why.

The correct settings are HIGH aspiration and BLOW-OUT dispense.

  • HIGH aspiration is correct because the pipette is greater than 5 mL.
  • BLOW-OUT dispense is correct because the pipette is specifically designated as a blow-out pipette.
  • Aspiration speed controls how quickly liquid enters the pipette, while dispense mode controls how liquid is released.