Chapter 6 Question's
Oil filters should be installed using?
A says gaskets can be removed quickly and safely with a hammer. B says that a dead blow hammer should be used with a chisel to cut the head of a bolt off
what car is bumble bee
yellow camaro
Which of these is used for driving and cutting
What is air drill
A says that you should always wear ear protection when using an air hammer. B says that standard wall sockets can be safely used with impact wrenches who is right?
Who is Tech A
Which style of torque wrench is the simplest and least expensive?
What is Beam wrench
A says when using a file, apply pressure to file in the direction of the cut and no pressure when pulling the file back. B says the the file cards are used to file un even surfaces.
Who are both Techs
whats faster gallo 12 engine or gallo 24 engine
gallos a pizza place
When soldering non-electrical connections, what should be used as the flux cleaning
What is Acid
A says that one of the first things to do when purging an acetylene torch is to turn off the valves on both bottles. B says that when setting the line pressures on an acetylene torch the torch should be adjusted so its above 15 psi
who is tech a
The depth of blind holes in housing can best be measured using a(an)?
What is Vernier calipers?
A says the feeler gauges is used to measure the diameter of small holes. B says that the feeler gauge and straight edge are used to check surfaces for war page.
Neither
who was the owner of the fastest "street legal" MK4 supra
Which of these is true of an air impact gun
why is it never used to finally finish tightening the lug nuts
A says that it is safe to use an air nozzle to blow dust off you or your coworker. B says that osha approved nozzles lower the tip pressure by venting some of the air for safety reasons
who is tech b
When a large Chisel needs a really strong blow use a?
What is a sledgehammer?
A says that torque wrenches need to be calibrated periodically to ensure proper torque values. B says that when using a clicker style torque wrench keep turning the torque wrench 1/8-1/4 turn to make sure the bolt is properly tightened.
Who is tech A
what's better bags or coil suspension
Bags
The advantage of using rose buds tips is that they
why do they lower the chance of flash backs
A says that a wire feed welder is used to braze components together. B says that sunglasses should be used when watching someone weld with a wire feed welder.
why is it neither
A set of safety practices and procedures that are intended to reduce the risk of technicians inadvertently using tools that have been determined to be unsafe is known as?
What is a tag-out
A says that when using a micrometer a "standard" is used to hold the part you are measuring. B says that the micrometer spindle should be firmly closed against the anvil prior to storage.
Who are both Techs
Who in the class has the biggest ego
theres no right answer sorry lmaoooooo but you still get it for answering
Chassis dynamometers are very useful for
why test vehicle performance
A says that gaskets can be removed quickly and safely with a portable grinder and high speed grinding stone. B says that extreme care must be used when removing a gasket on an aluminum surface.
Why is it neither