Semi auto 1
Semi auto 2
Semi auto 3
Semi auto 4
Semi auto 5
100

The continuously fed electrode improves what?

Deposition rates, reduces starts and stops, can be used semi- auto or automatic

100

Argon with what percentage of oxygen added improves weld bead contour and penetration?

1 to5%

100

Which gas is considered an active gas.

Oxygen

100

Which shielding gas is the least expensive?

CO2

100

How does  a suitcase welder get power to the drive rolls

Voltage sensing clip

200

GMAW power source is what type?

Constant voltage

200

Which shielding gas transfers the greatest amount of heat to the weld pool?

CO2

200

What part of the welding gun transfers the current to the  wire electrode?

The contact tip

200

Where is the flux located on flux cored wire

Inside the wire.

200

Which type of wire feeder do you have in your booth.Push or PULL Type

Push type system with four drive rolls

300

Which type of drive rolls are most often used for FCAW and MCAW wires?

Knurled

300

Wire electrode B-G49A6MG3 which letter designation indicates weld treatment

(A)

300

Which type of drive rolls are most often used for aluminum wires?

(U)

300

What two thing add Atmospheric protection to FCAW wire?

Externally supplied shielding gas along with flux ingredient within the cored wire.

300

Pull Type wire feeders are used for what.

Pull Type are used for softer wires such as aluminum.

400

With wire welding how is current or (amperage)controlled

By changing the wire feed speed.

400

With GMAW  wire B-G49A6MG3 which letter designation is used for shielding gas

(M)

400

What travel angle is optimal for open root applications with GMAW?

PULL(Backhand) 5-15 degrees

400

Electrode extension is referred to as ?

Stick out

400

Excessive pressure on the drive rollers  creates a situation where the wire cannot slip .The blocked end becomes entangled what is this called?

Bird's nest

500

Which shielding gas mixture is required for spray transfer?

At least 85% Argon

500

B-G49A6MG3 what number indicates tensile strength of the wire

(49)

500

None Ferrous alloys are often welded using what mode of metal transfer. Aluminum ,copper, nickel, titanium,

Spray or pulsed spray.

500

The power source maintains a constant voltage by adjusting output to match wire feed speed TRUE?FALSE

TRUE

500

List two inert gases

Argon and helium