A single blade that fits into a slot in the screw head.
What is Standard or Flathead Screwdriver?
100
Pliers that are the most common pliers used by an automotive technician.
What is Combination/Slip-Joint Pliers?
100
A punch that has a shank tapered all the way to the end. It is strong and can take moderate blows with the hammer.
What is Starting Punch?
100
Used to remove burrs, nicks, and sharp edges and perform other smoothing operations.
What is a File?
200
Wrench sizes given in millimeters.
What is metric?
200
Has two crossing blades that fit into a star-shaped screw slot.
What is Phillips Screwdriver?
200
Pliers that opens extra wide for holding very large objects. (Also pliers has several different adjustments or slots.)
What is Rib-Joint, channel lock, or water pump pliers?
200
Punch that has a straight shank and is lighter than the starting punch. It is to be used after the starting punch to push the shaft, rod, or pin the rest of the way out of the hole.
What is Pin Punch?
200
A type of file that has a large cutting edge and used on soft materials.
What is a course file?
300
Wrench that has an open, or split, jaw on both ends.
What is Open-End Wrench?
300
A special type of screwdriver that is shaped like a six-point star.
What is Torx Screwdriver?
300
These are pliers that are excellent for handling extremely small parts or reaching into tight/ restricted areas. Also pliers can be used to bend and cut wire.
What is Needle Nose Pliers?
300
Punch that has a long, tapered shaft and is handy for lining up parts during assembly.
What is Aligning Punch?
300
A type of file used with small cutting edges and usually used on harder material.
What is a fine file?
400
Wrench that is completely closed on both ends.
What is Box-End Wrench?
400
A screwdrivers used to get into tight places.
What is Offset/Stubby Screwdriver?
400
The most commonly used cutting pliers. Pliers are commonly used to cut cotter pins, wires, and plastic ties.
What is Diagonal Cutting Pliers/ Cutting Dikes?
400
Punch that is frequently used to mark parts for reassembly and start a hole before drilling.
What is a center punch?
500
A wrench that is a box-end wrench with a small opening or a split in the jaws.
What is Line, tubing,or flare wrench?
500
A tool that looks like a screwdriver, but it has a sharp, pointed, tip. This tool is used to mark sheet metal or other parts.
What is scratching awl?
500
Pliers that are used for clamping onto and holding parts and objects.