This type of recording space is typically more dead than a Live Room.
What is an Iso Booth
100
Preamplifiers are mainly used to amplify devices such as microphones and __ _____ to a nominal operating level.
What is a DI Box
100
If the Mic / Line switch is in the up position, then a channel will be set to receive a ___ level source.
What is Mic
100
During initial set-up of the master section, all 6 of the ___ ____ Masters must be brought up to the unity position.
What is Aux Send
100
During initial set-up of the Mackie 8-Bus Console the Master Fader needs to be brought up to the _____ position.
What is Unity
200
Storing computers and other recording related equipment in a machine room will reduce the amount of overall _____ in a control room.
What is Noise
200
Phantom power delivers __ _____ __ power to condenser microphones, active ribbon microphones, and active DI Boxes.
What is 48 Volts DC
200
If the flip switch is in the down position, then the Tape Return signal will be routed to the fader path, while the Mic or Line source will be routed to the ___ _ path.
What is Mix B
200
By default, the EQ Section on each channel of the Mackie 8-Bus console will not work until the __ __ button has been engaged.
What is EQ In
200
The CTRL Room Level that controls the volume of the speakers on the Mackie 8-Bus console can be found under the _______ _______ of the Master Section.
What is Monitor Section
300
A _______ ____ is where producers and engineers typically work during recording sessions.
What is a Control Room
300
The ____ pot, also sometimes referred to as gain, drives the incoming signal of a microphone or DI signal going into a preamplifier.
What is Trim
300
If the Channel 3 routing assignment is set for bus 7-8, then the panner will need to be panned hard ____ for the signal to be routed discretely to bus 8.
What is Right
300
Only Auxes ___ and ___ can be routed to either Phones 1 and Phones 2
What is 3-4, 5-6
400
A ____ ____ is where the majority of recordings take place.
What is a Live Room
400
Phantom Power is activated in groups of _ on the Mackie 8-Bus Console.
What is 8
400
To route any channel to the Master Fader, one must select ___ as the bus assignment.
What is L+R
400
The EQ In button on the Mackie 8-Bus Console does not need to be engaged in order for the 75 Hz ___ ___ ______ to function.
What is Low Cut Filter
400
The Mix B Monitor can be routed directly to the speakers as a source in the Monitor Section, or it can be routed to the ______ _____ by selecting Assign To L+R under the Mix B Monitor Section.
What is Master Fader
500
This room is used to house computers, multi-track recorders, and potentially tape machines or other recording devices.
What is a Machine Room
500
If the red LED on the Mackie 8-Bus console begins to flash on a channel this indicates that the channel is __________ or being overdriven resulting in clipping.
What is Overloading
500
To route the Mix B source to the speakers you can select Mix B as a source under the _______ section of the master section.
What is Monitor
500
The EQ Section of the Mackie 8-Bus Console consists of a Hi-Mid Parametric EQ, a Low-Mid Semi-Parametric EQ, and Hi and Low ________ EQ's.
What is Shelving
500
All of the Talkback routing buttons are _________, and do not latch when depressed.