Electrical Engineering
Mechanical Engineering
Plumbing Engineering
CA and Interdisciplinary Coordination
Funny / Office Coordination
100

What do you call the maximum short-circuit current a circuit breaker can safely interrupt?

What is the interrupting rating (AIC rating)?

100

What does HVAC stand for?

What is heating, ventilation, and air conditioning?

100

What is the purpose of a backflow preventer?

What is preventing potentially contaminated water from flowing backward into the potable water supply?

100

Who provides the starter for a 5-hp, 208-V, three-phase exhaust fan? The electrical contractor, controls contractor, or mechanical contractor?

What is Division 26 - Electrical Contractor? Also correct: what if the EF has an ECM motor?

100

What would you say if the architect changed the floor plan on the day of the drawing submission?

What is "Oh, heck no!" (Then talk to the project manager.)

200

What is the nominal voltage to ground on a 208Y/120V system?

What is 120 volts?

200

What are the three types of heat transfer, and how does each transfer heat?

What are conduction, convection, and radiation?

200

Commercial kitchen drainage systems commonly require this device to keep fats, oils, and grease from entering the sanitary sewer.

What is a grease interceptor?

200

What do RFI and ASI stand for?

What are Request for Information and Architect's Supplemental Instructions?

200

Should a mechanical engineer or designer route hydronic piping through an electrical room directly over electrical panels?

What is no? Coordinate with the electrical engineer and comply with dedicated electrical space requirements.

300

What units are commonly used to express electrical power and electrical energy?

What are kilowatts (kW) for power and kilowatt-hours (kWh) for energy?

300

New Mexico adopted the 2024 Uniform Mechanical Code and Uniform Plumbing Code in 2026. On what date does the transition period end?

What is January 1, 2027?

300

This static water pressure is the maximum allowed to plumbing fixtures per the 2021 UPC.

What is 80 psig?

300

What is the typical required horizontal separation between a plumbing vent terminal and an outdoor-air intake?

What is 10 ft. (25ft for Healthcare projects)?

300

What happens when mechanical, electrical, and plumbing systems all need the same ceiling space?

What is a coordination meeting?

400

What are the three types of overcurrent conditions that can occur in an electrical system?

What are overloads, short circuits, and ground faults?

400

This is the term for the mechanical power delivered directly to a fan’s shaft.

What is Brake Horsepower (BHP).

400

This domestic hot water temperature is the maximum allowed to be supplied to a public-use lavatory?

What is 120 Deg. F?

400

DOUBLE JEOPARDY! For HVAC equipment, what are MCA and MOCP used to determine?

What is (MCA) for conductor sizing and (MOCP) for the max breaker/fuse size?

500

For preliminary budgeting, what electrical service size might you initially consider for an 100,000-square-foot school before completing a detailed load calculation?

What is approximately 1,200 - 1600 A at 480Y/277 V?

500

This phenomenon occurs when the local pressure of a liquid falls below the liquid’s vapor pressure?

What is cavitation?

500

A building has 30 psi of incoming water pressure. The combined pressure losses from elevation and piping are 40 psi, and the highest plumbing fixture requires 20 psi of residual pressure. Approximately how much additional pressure must the booster pump provide?

What is 30 psi?

500

When performing a site observation, what is the first thing you should do when you arrive at the job site?

What is checking in with the general contractor or site superintendent, following site safety procedures, and using required PPE?