Brake Components
Tools & Equipment
Inspection Procedure
Problems & Solutions
Safety
100

What is the main function of the braking system?

To slow down or stop the vehicle.

100

What tool do you use to remove wheel nuts?

A wheel wrench.

100

What should you do before inspecting the brakes?

Park the vehicle safely and secure it.

100

What happens when brake pads are worn?

Braking performance decreases.

100

Why are brakes important for road safety?

They help prevent accidents.

200

What is the function of a brake disc?

It rotates with the wheel and provides a surface for the brake pads to clamp onto.

200

What tool do you use to measure brake disc thickness?

A micrometer.

200

What should you inspect on a brake disc?

Its thickness, surface condition and damage.

200

What can cause squeaking noises when braking?

Worn brake pads or other brake component problems.

200

What should you do before raising a vehicle?

Park on level ground and use suitable lifting equipment.

300

What is the function of a brake caliper?

It holds the brake pads and pushes them against the disc.

300

What tool do you use to measure brake pad thickness?

A brake pad measuring tool or vernier caliper.

300

Why should you inspect both inner and outer brake pads?

Because they can wear unevenly.

300

What does brake fluid do?

It transfers hydraulic pressure through the braking system.

300

Why must you never work under a vehicle supported only by a jack?

The vehicle could fall and cause serious injuries.

400

What is the difference between a brake disc and a brake drum?

A disc brake uses pads that clamp a rotating disc; a drum brake uses shoes that press against the inside of a rotating drum.

400

What is a brake fluid tester used for?

To check the moisture content or condition of brake fluid, depending on the tester.

400

Why must you compare brake disc thickness with the manufacturer's minimum specification?

To make sure the disc is safe to use.

400

What can cause a vehicle to pull to one side when braking?

Uneven braking force, a sticking caliper or other brake faults.

400

Why should you avoid touching brake discs immediately after driving?

They can be extremely hot.

500

What is brake fade?

A temporary reduction in braking performance due to excessive heat.

500

What tool can you use to check brake disc runout?

A dial indicator.

500

Describe the main steps in a visual brake inspection.

Inspect pads, discs, calipers, hoses, pipes and fluid level; measure components and compare them with manufacturer specifications.

500

A customer reports vibrations when braking. What components should you inspect?

Brake discs, pads, wheel condition and suspension components.

500

Why should you never reuse a damaged brake hose or install components outside manufacturer specifications?

Because brake failure can cause serious accidents.