Wood
If you buy 4/4 wood from the lumber store how thick will it be after Milling it?
3/4"
Which is larger 3/4" or 7/8"
7/8"
Which clamps do we never use during glue up?
Trigger clamps (quick clamps)
Name two types of hand planes
Bench plane, Should plane, Block plane, Router plane
When using the drill press what must always be underneath you work piece?
Backer Board ( Sacrificial wood)
Name two species of wood we used this year
Maple, Alder, or Oak
What is the decimal equivalent of 3/4"
.75
What is the best clamp to use for glue ups?
Parallel Clamps (bar clamps)
Name two types of hand saws in the woods lab
Back Saw, Coping Saw, Gentleman's Saw
When trying to figure out what drill bit to use what you measure on the screw?
Minor or Major Diameter
If you buy 6/4 wood from the lumber yard thick of wood will it yield
1"
Which is smaller 3/16" or 1/8"
1/8"
Name two types of clamps NOT previously stated
F Clamps, Squeeze Clamps, or Strap Clamps
What hand tool do we use to make a groove in the wood so we can chisel
Marking gauge
If I want my screw head to be below the surface of the what kind of drill bit do I use?
Counter sink drill bit
What is the best wood used for building furniture
Hardwood
What two machine to you use die calibers to measure the wood before run thru the machine
Planner and Time Saver
What is the name of the clamps attached to the benches
Vise
Name two types of squares
Carpenters Square, Kreg Square, Sliding Veritas Square, Combination Square
Which tool do I use to Drive Screw?
Impact drill or Angled drill
How much will 8/4 wood from the lumber yard yield?
2"
If my drawer bottom dose not fit when I dry fit how much do I take off?
1/16th then dry fit again to see if you need to take more off.
What is a Cal used for
To hold pieces flat when gluing them up
When chiseling what should you have between the bench and your work piece?
Bench hook
Name two types of drill bits
Brad point bit, Forstner bits, Kreg hole bits, Fluted Drill bits