Playdoh
type of line if you cut from right to left, leaving a top and bottom portion.
What is an parallel?
Struck by lightning, shocked by static, electricity is nature is this.
What is instant/sudden?
This process makes objects by laying down thin layers of liquid.
Extra large 3D print on display in the makerlab
What is the Hand?
the brain of the TI Rover
What is Hub?
TYPE OF LINE IF YOU CUT FROM TOP TO BOTTOM LEAVING A RIGHT AND LEFT HALF.
What is a PERPENDICULAR?
When a switch turns off the light, the circuit is in this state.
What is open?
Before each new layer, the 3D printer’s platform does this.
What is drop/lower?
OEDK, the K stands for this.
What is Kitchen?
located on the bottom and help to detect different colors.
What is a color sensor?
program used to design keychain.
What is Tinkercad?
Electrons have this charge.
What is negative?
Strike a pose! 3D printers work off of this information.
What is a model?
This low cost prototyping material is used to sculpt models and visualize ideas
What is modeling clay?
This command makes the Rover move forward
What is RV space forward?
HIGH TECH CUTTING DEVICE USED TO SLICE THE PLAYDOH MODEL
What is FISHING LINE?
Like water, electricity flows in this.
What is current?
Like yarn for a sweater, 3D printers uses plastic this to make prints.
What is filament?
What section is located upstairs contains soldering equipment
What is clubs and electrical rooms?
The Logic Challenge was to draw this image without crossing any lines or going back over a line without picking up the pen
What is a house?
EACH LAYER/SLICE OF 3D PRINITNG IS CALLED
What is CROSS SECTION?
Rubber acts as this on the outside of wires.
What is an insulator?
I’m going to print and adjust and repeat til I get the final solution. The test prints are called this.
What are prototypes?
You’ve sat here all week, at this room number.
What is 7?
When using a microbit you connect this part to a computer.
What is USB cable?