Electrical
This system monitors electrical infrastructure performance
What is EPMS
This unit of measurement is used to quantify the amount of heat removed by a cooling system.
What is a BTU (British Thermal Unit)
This panel monitors and control fire alarm system
What is the FACP
A space where loss of environmental control can impact IT equipment
What is a Critical Space
Allows any individual to stop work when unsafe conditions are present.
What is Stop Work Authority? Who has it?
This grounding system limits ground fault current
What is High Resistance Grounding (HRG)
This cooling method uses low outdoor air temperatures to reduce or eliminate chiller operation.
What is free cooling
This workstation provides fire system monitoring and control
What is FPWS
This redundancy model supports full load with one additional component
What is N+1
Identifies hazards, assesses risk, and defines controls to mitigate those risks before starting work.
What is the purpose of a Task Hazard Analysis/Job Hazard Analysis?
This device transfers load between normal and emergency power
What is an Automatic Transfer Switch (ATS)
This cooling process lowers air temperature by evaporating water into the airstream.
What is evaporative cooling
This system detects smoke through air sampling
What is VESDA
What is availability
A critical safety control where the reader verbalizes each step and the performer confirms and executes it to prevent error.
What is the reader performer routine and how does it work?
This equipment distributes power closer to the IT load
What is a PDU or RPP
This type of cooling relies on compressors, refrigerant, and electrical power to remove heat.
What is mechanical cooling
This fire system requires smoke and heat detection before releasing water
What is a Pre-Action system
This phrase describes 99.999% system uptime
Ensures hazardous activities are reviewed, approved, and controlled before execution
What is the Permit to Work (PTW) Program
This procedure prevents unexpected energization during maintenance
What it Lockout / Tagout (LOTO)
This unit uses compressors and refrigerant to remove heat from data hall air and maintain temperature when chilled water is not used.
This fire system uses pressurized air or nitrogen until activation
What is a Dry Pipe system
This redundancy model provides two independent paths capable of supporting full load
What is 2N
Following fire SMPs, maintaining good housekeeping, reporting impairments, responding to alarms, and escalating incidents per site procedures
What are fire prevention and control responsibilities.