Blade 3
Burn marks on the stock and sawdust buildup on the blade are indications that:
The BLADE is dull.
To cut a tapered piece on a table saw use a:
tapering jig.
A mitre saw that slides on rails and the blade tilts is called a:
Compound mitre saw
The saw that moves horizontally in a complete circle is a:
Radial Arm Saw
A groove is a wide cut part way through the thickness of the material and ______ the grain.
Across
or
With
with.
_________ is a feature of a circular saw blade that allows for the expulsion of sawdust from the cut during operation.
The gullet
If a small piece of cutoff wood is close to a moving blade of a table you should use a:
Pushstick
The mitre saw was specifically designed for what type of cuts?
crosscutting
When using a radial arm saw,
a) wear gloves
b) hold the material loosely against the fence
c) wear eye and ear protection
d) all the above
c)
A dado is a wide cut part way through the thickness of the material and ____ the grain.
Across
or
With.
Across
Saw arbor nuts are tightened which direction?
Against the rotation of the blade.
The best tool to use to cut the edge of a board parallel to its other edge is the:
Table saw
The danger to using a dull blade is that:
a) the blade will overheat
b)the blade will wobble at high speed
c) there is a possibility of kickback
d) all the above
D.
The tool that has largely replaced the radial arm saw on jobsites is the:
Sliding mitre saw
Recesses cut in wood to receive hinges are known as:
Gains
A blade that satisfactorily cuts plywood with little splintering of the cut edge is a(n):
a) ripsaw blade
b) crosscut blade
c) abrasive blade
d) masonry blade
b) Crosscut blade
Compound mitre cuts can be made on a table saw with the:
a) fence adjusted and the blade tilted
b) mitre gauge turned and the blade tilted
c) mitre gauge turned and fence adjusted
B.
Stop block
Which type of blade would a radial arm saw use?
crosscut blade or combination blade
A rabbet is a wide cut part way through the thickness of the material and _____.
Along/right on the edge
A blade that has teeth that are ground at right angles to the edge is a:
Ripsaw blade
The table saw guide used for cutting across the grain is called?
Mitre gauge.
When operating a sliding mitre saw you should do what?
3 steps:
1. pull the blade toward the operator,
2. then push down,
3. and back to cut the material
True or False.
True
The size of the radial arm saw is determined by the:
Largest blade that can be used
A saw cut all the way through a board in which the saw blade passes is called a _______.
Kerf