Forces & Plate Boundaries
Name That Fault
Rock & Fault Details
Shake, Rattle & Waves
Tracking an Earthquake
Measuring & Understanding Earthquakes
Final Jeopardy
100

This type of stress squeezes rocks together.

compression 

100

A crack in rock with no significant movement on either side is called this.

Joint

100

The surface where two rock sections meet along a fault is called this.

Fault plane

100

Shaking of the ground caused by seismic waves is called this.

Earthquake

100

Scientists use this instrument to record ground motion during an earthquake.

Seismograph

100

This scale reports earthquake magnitude rather than local damage.

Richter scale

100

An earthquake is recorded at three seismic stations. Their distance circles meet near Pine Valley. Pine Valley has strong buildings on bedrock, while nearby Lakeview has older buildings on soft soil. Lakeview suffers more damage.

  1. Which body wave should reach a station first, and why?
  2. What method uses the three distance circles?
  3. What is the surface location identified by their intersection called?
  4. Give one reason Lakeview suffered more damage.
  • P-wave, because it travels faster than the S-wave.
  • Triangulation.
  • Epicenter.
  • Lakeview’s soft soil can increase shaking, or its older buildings may withstand shaking less well.
200

Rocks are being pulled apart. They are experiencing this type of stress.

Tension

200

Rock on opposite sides of a crack has moved relative to the other side. The crack is classified as this.

Fault

200

A geologist records the direction a fault runs. This measurement is called this.

Strike

200

Of the two body waves, this one travels faster.

P-wave

200

The underground point where an earthquake begins is called this.

Focus

200

This scale describes earthquake intensity using observed effects and damage at a location.

Modified Mercalli Intensity scale

300

Forces push along the sides of rock in opposite directions, producing this stress.

Shear

300

Along an inclined fault, the upper block moves downward relative to the lower block. Name the fault.

Normal fault

300

A geologist measures how steep a fault is from horizontal. This measurement is called this.

Dip

300

This body wave travels through solids but cannot pass through liquids.

S-wave

300

The point on Earth’s surface directly above where an earthquake begins is called this.

Epicenter

300

A magnitude 6.0 earthquake releases approximately this many times as much energy as a magnitude 5.0 earthquake.

31.6 times

400

Two plates move away from each other at this type of boundary.

Divergent boundary

400

Along an inclined fault, the upper block moves upward relative to the lower block. Name the fault.

Reverse fault

400

A material bends without breaking. This word describes its behavior.

Ductile

400

Love waves and Rayleigh waves belong to this group of seismic waves.

Surface waves

400

Scientists use P–S arrival-time differences to find distances from three stations. They draw distance circles to locate the epicenter using this method.

Triangulation

400

An underwater earthquake suddenly displaces a large volume of water, producing this hazard.

Tsunami

500

Two plates collide, sometimes forming mountains or causing one plate to sink beneath another. This is the boundary type.

Convergent boundary

500

At a transform boundary, rock blocks slide sideways along this type of fault.

Strike-slip fault

500

A locked fault has not slipped, but tectonic forces continue acting. This builds up until the fault suddenly slips.

Stress

500

Days after a major earthquake, smaller earthquakes occur as the area continues adjusting. These are called this.

Aftershocks

500

Scientists use this mapping technology to display faults and earthquake-prone areas.

GIS

500

Two towns experience the same earthquake, but one has much greater damage. Which earthquake measurement differs between the towns?

Intensity