General Req.
Locate the section that explains what types of welded structures AWS D1.1 applies to.
What is
Clause 1.1 – Scope
Which clause contains all referenced standards used by AWS D1.1?
What is Clause 2 – Normative References
Two inspectors disagree on the meaning of a code term. What clause settles the disagreement?
What is Clause 3
Where would you locate design requirements for fillet welded joints?
What is
Section 4.9
Which clause explains welding symbols?
What is Clause 1 section 1.8
The Word "Should" indicates
What is recommended practices
Clause 1 Section 1.7.1.2
The normative reference for carbon steel electrodes use for FCAW ?
What is A5.20
Clause 2
The contractors inspector is
What is the duly designed person who acts for and in behalf of the contractor on all inspections
Clause 3 Def
Which section contains inspection requirements for cyclically loaded connections?
What is
Section 4.19
Which section discusses joint configuration and groove welds?
what is
Section 4.8
Which section explains the responsibilities of the Engineer, Contractor, and Inspector?
Clause 1.5 – Responsibilities
The specification used for SMAW electrodes
What is AWS A5.5
Clause 2
A intermitten weld is defined as?
What is a weld in which the continuity is broken by recurring unwelded spaces.
The maximum weld size in a lap joint along the edges of base metals in base metals less than 1/4" shall be ?
What is 1/4" (Thickness of the base metal"
Clause 4 section 4.4.2.9 (1)
Which section discusses prohibited joints and welds for cyclic loading?
What is
Section 4.18
Safety and Health information is available from the following sources?
What is ANSI Z49.1 and AWS Safety and health fact sheet
Clause 1 Section 1.3
What specification is used for Structural buildings?
What is AISC 360
Clause 2
A tack weld is defined as
What is a weld made to hold parts of a weldment in proper alighnment until the final welds are made.
Clause 3 Def
The shape and size requirement for weld access holes shall apply to which section
What is 7.16.1
Clause 4 4.7.6 to Clause 7 7.16.1
What table is used to find the Effective size of a flare groove weld?
What is table 4.1
Clause 4
Who is the engineer
Clause 1 Section 1.5.1
The Structural welding code for Seismic is ?
What is D1.8
Clause 2
Clause 3 Def
Minimum spacing of slot welds in a direction transverse to their length shall be?
What is four times the width of the slot.
Clause 4 section 4.10.2
When welding two or more rolled shapes, the Max spacing of intermittent fillet welds shall be?
What is 24"
Clause 4 section 4.12.2.1