Rotating System
is a device used to grip and hold the drill pipe to the rotary table on the rig floor on an oil rig and consist of 3 segments.
Rotary Slips
A drill string component, The lightest Tubular steel conduit fitted with special threaded ends called tool joints. it connects the rig surface equipment with the bottomhole assembly and the bit,
DP
It is a part of well control system, it helps seal the space around the drill pipe during a “kick.”
BOP ram
It is used to raise the drill collar from the pipe rack to the rig floor using the air hoist.
Lifting Sub
It is a part of mud pump serves to reduce pulsation produced in operation and to assure stable discharge flow and pressure.
Pulsation Dampener
is a device used to grip and hold the drill collar to the drill floor on an oil rig and consist of 7-10 segments.
DC Slips
It is lowest part of the BHA, used for drilling through rock by crushing the rock and commonly has 3 cones.
Roller cone bit
A valve that normally allows fluid (liquid or gas) to flow through it in only one direction.
one way valve
A mechanical device attached to the traveling block that latches around and supports the pipe during hoisting or lowering operations. It is open from the side.
Elevator
A manifold on the rig floor is installed downstream of the mud pumps with the purpose of diverting the flow of drilling fluids toward the stand pipe and then the rotary hose.
Stand Pipe Manifold
is designed to enhance safety when working with high pressure pipes and eliminating injuries related to pipe failure accidents.
Safety Sling
A drill string component, a thick-walled tubular that is used at the bottom of the drill string, is mainly used to provide weight to the drill string and it’s designed to reduce the stuck.
Spiral DC
A device placed on the rig floor that can be operated by the driller to close BOP,
BOP Remote Control Panel
A hoist is designed to lift people or systems carrying people on the rig floor.
Man Rider
It is a valve used on the suction side of the pump (on the low-pressure side of the circulating system), used to stop or direct the flow of mud.
Butterfly Valve
refers to the electrical, pneumatic, and hydraulic supply lines which are required to provide service to a top drive drilling motor in oil and gas drilling applications.
Service Loop
It has the same gauge as the bit, helps to keep the hole in gauge in case the bit is worn.
Reamer
It is a part of well control system, a unit provide power to the BOP. Energy is stored by using bottles of nitrogen and hydraulic fluid.
It prevents the traveling block from hitting the crown block.
Crown-O-Matic
It is a part of the BHA, helps to centralize the bit and BHA, this helps to keep the hole straight and prevent damage to the BHA.
Stabilizer
is a device used in conjunction with the drill collar slips to grip and hold the drill collar in the rotary table on the rig floor as the drill collar doesn't have a tool joint.
Safety Clamp
It prevents the drill bit from turning while the bit sub on top of it is tightened or loosened.
Bit Breaker
This valve is a non-return valve (check valve) installed above the FOSV allowing pumping drilling fluid through the valve into the drill string.
IBOP
It is a cap used to raise and lower the tubular from the pipe rack to the rig floor using the air hoist.
Lifting Cap
are specialized connectors that connect between high pressure lines
Quick Union