PRE-TRIP INSPECTION
BACKING & JOBSITE HAZARDS
DRIVING & TRANSPORTING SAFETY
PPE & PERSONAL SAFETY
EMERGENCY & SAFE PRACTICES
100

What component must be checked to ensure the drum will not free spin during transport?

The drum lock or interlock system

100

What is the safest method to back a mixer on a jobsite?

Use a spotter 

100

Why is a concrete mixer truck more prone to rollovers?

Higher center of gravity and liquid load movement

100

What PPE protects against cement burns?

Gloves and long sleeve shirts 

100

What should you do if your mixer becomes unstable during unloading?

Stop discharge immediately

200

What fluid is critical to check to prevent loss of steering during operation? 

Power steering fluid 

200

How many points of contact should you maintain when exiting the cab?

Three points of contact

200

What driving action should be avoided when carrying a full load?

Sudden braking or sharp turns 

200

What footwear is required to prevent slip and crush injuries?   

Slip-resistant steel toe boots 

200

Who should be notified immediately after a jobsite incident? 

Supervisor or dispatch 

300

What should you inspect for proper inflation and visible damage before every trip?

Tires 

300

What is a mixer driver's blind spot area called? 

The "no-zone" 

300

What road feature requires extra caution due to liquid surge? 

Curves and ramps 

300

What PPE is required when working near traffic? 

High-visibility vest 

300

What should be done before attempting minor truck adjustments on site? 

Set brakes and secure the vehicle 

400

What system must be working properly to warn others when backing up?

Backup alarm

400

What should you do before backing if no spotter is available? 

Get out and look (GOAL) 

400

What should be done before entering a construction zone with reduced clearance? 

Slow down and increase following distance 

400

Why should eye protection be worn during discharge? 

To protect from splashing concrete 

400

Why should you never climb on a moving drum or chute? 

Risk of entanglement and falls 

500

What should be checked to ensure the mixer chute can safely support concrete flow?

Chute pins and locking mechanisms 

500

What surface condition increases rollover risk on jobsites?

Uneven or soft ground 

500

What is the safest speed adjustment when driving in wet conditions with a load? 

Reduce speed significantly

500

What should you do immediately if wet concrete contacts skin? 

Wash it off thoroughly with clean water  

500

What is the most important safety responsibility of a mixer driver?

Stop work if conditions are unsafe