machine safety
OSHA
wood types
finishing
general construction
200
What should you never stick in any operating tool
hands fingers any bodypart really
200
What PPE should you always have on a job site
eye protection/gloves / hard hat/visibility vest / work boots.
200
What type of wood are these 
hard woods
200
This hazard can occur when cutting wood for finish work if the material kicks back suddenly from a saw blade.
kickback
200
What do masons use when laying bricks to seal the bricks and make them stronger
rebar and morter
400
This rule is in place to prevent falls from ladders
three points of contact
400
This type of protection is required when a worker could fall 6 feet or more on a construction site.
fall protection
400
what kind of woods are these 
dimensional lumber/soft woods/ 2x4s?
400
This hazard can happen if sawdust builds up on the floor during finish work and causes a worker to _____
slip or trip hazard
400
what kind of tool do you use to cut metal frames
tin snips
600
Extension cords create this type of job-site hazard.
slips/trips/falls
600
When spotting a machinery operator, what is the most important part
maintaining eye contact
600
what kind of wood is this 
maple
600
This tool safety rule requires you to keep your hands away from the blade and use a push stick when cutting small pieces on a table saw.
push stick
600
What does GFCI stand for
ground fault circuit Interrupter
800
What PPE should you not use when operating a table saw
gloves
800
What is a Lockout/Tagout
A safety procedure that makes sure machines are fully shut off and can’t turn back on during repairs.
800
What kind of wood is this 
cherry/walnut/purple heart
800
Why is it important to go up in grit number when sanding
to erase the deep scratches left by the previous step, or to be more efficient
800
what is pvc mainly used for
Drain and waste pipes
1000
What should an operator do if they lose sight of a spotter while backing up equipment?
Stop the machine until visual contact is restored.
1000
This type of worker is required on most job sites and is responsible for identifying hazards and making sure safety rules are followed.
competent person
1000
What kind of wood is this 
popler
1000
Name 5 tools in the shop that are used for finish work
table saw/sander/dado saw(but you don't know that)/band saw/router/planer/glue/sandpaper/clamps.
1000
name everything 7/8 for credit
A=header
B=top plate/double top plate
C=common stud
D=bottom plate
E=cripple stud
F= king stud
g=sill plate
H=bottom cripple