The official name for this tool, commonly referred to as linesman pliers
What are side cutting pliers?
This item is used in most conduit runs. Its makes for a good splice point.
What is a four square junction box?
Calculate the voltage drop over an 8 ohm resistor, if the circuit is pulling 6 amps.
What is 48 volts?
The force that causes electrons to flow in a circuit.
What is voltage?
What does "PPE" stand for?
What is personal protective equipment?
The organization that writes the National Electrical Code.
What is the National Fire Protection Association?
What is the official name for this tool?
What are diagonal cutting pliers?
You'll spend a lot of time installing this specific device.
What is a duplex receptacle?
Calculate the voltage of series circuit pulling 20 amps and having a resistance of 6 ohms.
What is 120 volts?
The rate at which electrical work is done when one ampere of current flows through one volt
What is a watt?
What does GFCI stand for?
What is Ground Fault Circuit Interrupter?
This article of the NEC covers definitions?
What is Article 100?
The name of this tool, which is commly used to make holes in concrete or brick.
What is a hammer drill?
This item is good for mounting conduit to walls.
What is a one hole strap?
Calculate the wattage of series circuit pulling 3 amps and having a resistance of 4 ohms
What is 36 watts?
The opposing force to current in a circuit
What is resistance?
What does LOTO stand for?
What is Lock out, Tag out?
In the NEC what does "AHJ" stand for?
What is the Authority Having Jurisdiction?
Use this tool to mark the center of light over the floor.
What is a plumb bob?
This item is good for supporting multiple conduit runs.
What is Unistrut?
A series circuit has 3 resistors measured at 7 ohms, 11 ohms, and 9 ohms. What is the circuits total resistance?
What is 27 ohms?
The flow of electrons in a circuit
What is current?
What should you do before working on any circuit?
What is make sure the circuit is de-energized?
What is Grounding and Bonding?
What is the official name of this tool?
What is an adjustable wrench
Name this conduit body.
What is a C?
Calculate the total resistance of a parallel circuit with one branch having a resistance of 4 ohms and the other having a resistance of 12 ohms
What is 3 ohms?
The main difference between electron flow theory and conventional flow theory.
What is electron flow theory is negative to positive whereas conventional flow theory is positive to negative?
What year did the President sign the Occupational Safety and Health Act?
What was 1970?
The circuit conductors between the final over-current device protecting the circuit and the outlet
What is branch circuit?