General Pub Knowledge I
What does TPDR stand for?
Technical Publication Deficiency Report
Who resolves any issues between the LWS and any publication?
Commander, Naval Air Systems Command
COMNAVAIRSYSCOM
What does WAM stand for?
Weapons Assembly Manual
Where do you find the AN/ALE-47 dispenser magazine inspection, build up and breakdown procedures?
NAVAIR 11-140-7
Where do you find the proper cable routing for LAU-118
LWS-000 Section 3 page 3-18/19
What does IRAC stand for and what is the title of the page in the LWS that lists the applicable IRACs?
Interim Rapid Action Change
List of Effective Pages
Where do you find specific flight authorization?
NTRP 3-22.2-EA18G or Flight Clearance Message
When shall visual inspection of ammunition handling equipment be performed?
What is the empty weight of the countermeasures dispenser magazine?
7.75 lbs
What is the ETI on the AGM/CATM-88
Elapsed Time Indicator
If there is a discrepancy between the LWS and any other publication, the provisions of which manual shall prevail?
LWS-000
How many HERO manuals are there and what are they?
NAVSEA OP 3565
NAVAIR 16-1-529
NAVELEX 0967-LP-624-6010
What does SDCC stand for?
Signal Data Converter Control
What is the loaded weight of the countermeasures dispenser magazine?
28.3 lbs
What does PASE stand for?
Preloading Accessory Suspension Equipment
Where do you find the most up to date publications?
NATEC
What is table 5-3?
Single Store Hoisting Band/Adapter Installation
How many SDCCs are in the jet?
9
A dispenser block is usable unless there is...
Which way do you turn the arming key to arm the AGM/CATM-88
Counter Clockwise
What is the only exception to the LWS takes prescedence rule?
Paragraph 1-3 in the LWS-000.
*Letter of Promulgation number 4
What is table 5-2
Cartridge Requirements
What are the aircraft preparation steps in order?
Verify R&C completed
Aircraft Grounded
Power Removed
Switches Positioned
WEAPONS LOADED sign in cockpit
Ground safety handle locked on all loaded stations
It is permissible for upper surface of the payload to extend above the dispenser block surface by approximately how far?
0.025 inches
What is the AGM/CATM-88B/C cable part number used for stations 2 and 10?
74A756228-9GAA