Category 1
Category 2
Category 3
Category4
Category 5
100

Fall protection is generally required in construction at this height.

What is 6 feet?

100

This document must be available on every jobsite and contains chemical hazard information.

What is an SDS ( Safety Data Sheet)?

100

The Latin term Quid Pro Quo is defined as?

What is " This for that"?

100

This government agency was created in 1970 to ensure safe working conditions.

What is OSHA?

100

What is the minimum safe working distance from power lines of an unknown voltage.

What is 10 feet?

200

Most manufactures specify that fall protection gear be retired/replaced after how long?

What is 5 years?

200

The type of traffic vest needed by highway workers depends on this.

What is Vehicle Speed?

200
This is the most extreme level of heat illness.

What is Heat Stroke?

200

When properly positioned for use, an extension ladder should be angled at a ___ to ___ ratio.

What is 4:1

200

This type of permit may be required for hot work?

What is a Hot work permit?

300

When used as fall prevention, guard rails must include a top rail which is between ___ inches above the working level.

What is 42 plus or minus 3. ( 39-45" )

300

When water is present in the trench, the soil type is automatically Type ___ soil?

What is Type C soil?

300

This is another name for procurement.

What is purchasing?

300

According to the hierarchy of controls reviewed in class, what is the most effective and desired hazard control method.

What is Elimination?

300

Fuel gas cylinders should be placed in this position during use.

What is vertical?

400

What is the name of the piece of wood placed under the scaffold on unstable surfaces.

What is a mud sill?

400

OSHA's Focus Four hazards are Falls, Electrocution, Struck-By, and....

What is Caught-In/Between?

400

When used to gain access to a higher elevation, extension ladders must extend a minimum of ___ inches beyond the level being accessed.

What is 36 inches (3 feet)?

400

" AGC" stands for.

What is Associated General Contractors?

400

This is the standard procedure used to safely de-energize equipment on circuits before any work is conducted upon them.

What is Lock Out/ Tag Out?
500

This ANSI standard applies to approved occupational eye and face protection used on construction job sites

What is ANSI Z87?

500
This is the PEL for silica?

What is 50 ug/m3?

500

OSHA considers oxygen levels below this percentage to be oxygen-deficient.

What is 19.5%?
500

Spoil piles and excavated material must be kept at least this far from the edge of an excavation.

What is 2 feet?

500

In Home Improvement who plays Tim Taylor known for his obsession with power tools and host of "Tool Time"

Who is Tim Allen?