Show:
Autobody 1
Autobody 2
Autobody 3
Autobody 4
Autobody 5
100
Which of the following type of paint is easiest to match...Solid, Metallic, basecoat, tri-stage
Solid
100
The simplest way to remove swirl marks is by...Glazing, sanding, buffing, waxing
Glazing
100
Two part putty consist of ...Putty and Filter, Resin and Hardener, putty and Hardener, putty and Sealer
Putty and sealer
100
A dry spray causes the paint surface to look- , slick, rough, wet, shiny
Rough
100
Air bubbles under a decal are removed with a - Chisel, file, squeegee, sanding block
squeegee
200
Fresh paint can be forced dried at - 140 degrees, 180 degrees, 200 degrees, 220 degrees
140 degrees
200
Exterior molding are attached using all of the following except...Silicone adhesive, self-stick backing, two-sided tape, clip
Silicone adhesive
200
All of the following are vehicle substrates EXCEPT...Steel, Flexible plastic, rigid plastic, tempered glass
Tempered glass
200
Paint on a surface where it does not belong is called - Overspray, dry spray, back spray, off spray
Over spray
200
Cured primer - surfacer is leveled by - Featheredging, block sanding, taper sanding, grinding
Block sanding
300
A clear coat surface has minor discoloration from tree sap. Painter A says that you should sand and buff. Painter B says that you should sand and repaint. Who is right?
A only
300
All of the following are examples of airborne industrial contamination EXCEPT...Rail dust, Acid Rain, Tree Sap, Soot..
Tree sap
300
Which of the following is a problem associated with clearcoat application?..Orange peel, runs
Both Orange peels and Runs
300
Which of the following is water soluble contaminate- Oil, wax, road salt, grease
Road Salt
300
Painter A uses a tack rag to pick up lint. Paint B uses a tack rag to pick up hair. Who is correct
Both A and B
400
Painter A says that graphics decals must be applied to bare metal. Painter B says that a graphics decal is applied only after all painting operations are complete. Who is right?
B Only
400
All of the following are ways to prep for a blend except - 1000 grit wet sand paper, 800 grit sandpaper, light scuff pad, 320 grit dry sand paper
320 grit sandpaper
400
The front door on a vehicle has been painted. There is a slight mismatch. What should the painter do? Blend the rear door, Blend the fender, Blend the fender and the rear door, Blend the fender-rear door and quarter panel.
Blend the fender and the rear door
400
All of the following are methods of molding attachment EXCEPT - Welding, clipping, gluing, bolting
Welding
400
Painter A says that pinstripes can be applied with stripe tape. Painter B says that pinstripes can be painted on. Who is right
Both A & B
500
As the paint is poured into the spray gun, it should be- Mixed, reduced, catalyzed, strained
Strained
500
Which of the following is LEAST-Likely to be picked up by a track rack....Lint, Hair, Small dirt particles, Water
Water
500
At what time during the repair process should dirt and road grime be removed for the area of the repair. After removing all trim, After priming the surface, after painting, after sanding and body filler work
After removing all the trim
500
Isocyanates are found in, - Lacquer paint, Catalyzed paint, Lacquer primer, Lacquer Sealer
Catalyzed paint
500
Washing uncured paint will result in - Runs, rust, water spotting, mottling
Water spotting