This procedure is meant to protect you from sources of stored energy.
What is lockout/tagout?
100
This must be tested daily on the steepest road on which your light vehicle travels.
What is the parking/emergency brake?
100
This is the minimum distance of solid ground needed to work above voids.
What is 30 feet?
200
Before entering an active pattern you should do this.
What is make contact with the driller(s)?
200
Once a pattern has been blasted, with or without stopes, you must wait a minimum of this long before entering the area, so that "ample time is given for settling of material after blast."
What is 24 hours?
200
In addition to thermal, mechanical/physical, chemical, pneumatic, and hydraulic, it's another form of stored energy.
What is electrical energy?
200
This is the maximum speed on retreads (dependent on conditions).
What is 45 mph.
200
"Underground workings when possible should be drilled and limits identified at a minimum" of this many feet below bench grade.
What is 50 feet?
300
"Do not work directly underneath and/or parallel to the highwalls without" this "and/or an approved work plan within 10' of the ghighwall face or at distances that have been identified to have potential hazard..."
What is a spotter?
300
When a blast is in progress, do not interrupt this except in the case of a mayday or breached perimeter.
What is radio silence?
300
True/False (Forgive the non-Jeopardy format): You must tag out a light vehicle when washing it in the wash bay.
False (but used to be true).
300
This safety device must be functional in your vehicle inspection in order to drive, and all visiting vehicles must check one out from the warehouse.
What is a strobe/"blinky light."
300
These color flags indicate stopes that do not require drilling within broken muck on the bench and to proceed with caution.
What are green flags?
400
There is a specific policy in place that requires personnel to avoid trying to do this with tires.
What is remove a rock from the tire?
400
When a pattern is being loaded, this is the minimum distance you must stay without approval from Buckley.
What is 50 feet?
400
This is the actual name for the yellow tags used on mobile equipment that is broken and should not be used.
What is an Out of Service tag?
400
You should turn off this, then run the water for a period of time (3-5 minutes) before shutting off the shop steam cleaner.
What is the burner (and soap)? NOTE: this policy needs some signatures still.
400
These color flags indicate mucking must cease and engineering must be contacted for instructions.
What are green and white flags?
500
When in the pit, you are required to wear safety glasses, a hardhat, steel-toed boots, and this.
What is high-visibility outerwear/vest.
500
In addition to filling out a hot shot report, these two things must be done at the site of a hot hole.
What is no muck the area and survey the hole?
500
If the employee who locked out a piece of equipment has left site and cannot be contact despite "all reasonable attempts," only this person may initiate the procedure to unlock it.
What is the "authorized supervisor."
500
The one-minute (five-minute when below freezing) no idle policy is in effect between these two dates.
What is April 15th - September 15th.
500
These three types of intervals may be are recorded on stope drilling sheets.