Beacon
What are the five beacon colors that appear on the Rika device?
yellow, red, blue, cyan, and purple
What is the alarm number for low access pressure?
4602
These are the alarm codes associated with a fluid leak.
What is 4500 and 4501?
What is the name of the place that defective soft goods reports are completed?
Myata portal
How do you treat an RBC loss?
Oral fluids and a 15 minute rest
What is the priority type associated with a slow flashing yellow beacon?
medium priority
What is the alarm number for high access pressure?
4603
What can happen if the rollers on the centrifuge are not cleaned properly?
The rollers can get stuck due to dried blood.
This softgood is normally associated with a fluid leak.
What is a separation set?
If a bottle contains over 200 ml of RBCs, is it a greater than or less than RBC loss?
Greater
What is the priority type that is associated with a solid yellow beacon?
low priority
How long can the device be paused until you can't continue with the donation?
9 minutes and 30 seconds (unless its a restick)
What liquids are used to clean the device during a fluid leak?
Water and Alcohol(70%)
True or false: Is it considered air contamination if the filter is not on the plasma bottle?
True
If a donor has an unresolvable alarm before they give any plasma is it an RBC loss?
No, unless there is a noticeable amount of blood in the separation set bag.
What is the priority type that is associated with a red beacon?
high priority
If an alarm ends a donation early what would you document it as on your PDA?
Discontinued
What needs to be passed in DMS before a fluid leak device can be put back into service?
The fluid leak cleaning.
If you do not have access to the Myata portal, who can you contact to perform a defective goods report?
Machine techs and group leads
How many less than RBC losses can a donor have before they are deferred?
2
What does the blue and cyan beacon color represent on the device?
procedure notification and alerts
Where do you document alarms if they occur outside of the donation or are not on the PDA?
Instrument Event Log
How do you put a fluid leak device out of service in DMS if the alarms were not placed?
Find the device in the equipment section, click on record equipment incident, select leak detected for the reason, select error management form for the issue type, select N/A for issue priority, in the comment section describe the leak, and hit finish?
True or False: Do you still do a defective soft good report even if the loop break was due to a setup error?
True
If the collection bottle contains no RBCs and the device is ended early with a volume of 385, would the RBC loss be considered a greater than 200 ml or less than 200 ml?
Less than