Dothan
What is the correct downtime code for Start up or Shut Down?
a. 29
b. 10
c. 26
d. 21
d. 21
What is the correct downtime code for Partie Centrale?
a. 13
b. 24
c. 20
d. 7
c. 20
What is the correct downtime code for NSM molds?
a. 13
b. 9
c. 18
d. 10
b. 9
What is the correct downtime code for Waiting on Membranes?
a. 4
b. 12
c. 20
d. 25
d. 25
What is the most appropriate code for a shut-down (applies to holiday or planned downtime)?
23 - Not Scheduled
What is the most appropriate code for a press down for 38.1/38.2?
5 - OCN Quality
What is the most appropriate code for a Press that is requiring preventative maintenance and will be down for half a shift?
15 - NSK Press PM or Lube
What is the most appropriate code for a press that is not planned to run until a customer order?
23 - Not Scheduled (pdp)
Press is shut down for 34.1/35.2s mitigation, which downtime code should it be on?
OCN Quality
Quality Team authorizes you to shut down a press for a product related issue. Which downtime code should be selected?
6 - Chain Quality
Mold sprayer is not present but press is due to be sprayed. Which downtime code should be selected?
26 - Tire stuck in mold
A membrane has reached it's life expectancy and will need to be changed but none are built yet for that membrane type. Which code should be selected?
25 - Waiting on Membranes
T-sets are full and it's bottlenecking the plant. Due to this, H/C's are elevated in TVA and T&G, you are directed to hold up presses. Which code should follow?
8 - Cooling circuit full
This code is automatically coded if the press stops off for no reason. Should not be manually used by operator. Which code?
1 - no code entered
The press is on no code after finishing the last cure cycle, what code needs to be selected?
4 - LOC
Press is attempting to call a dimension from the assigned belt and fails (with plenty covers in magazine). Which code should be selected?
13 - NSK Magazine
You have run out of all covers in the magazine to each respective press. What should be performed next?
Wait 20-30 min and select all presses assigned to that dim to stop end of cycle and code it to 4 - LOC.
Press has a fault and you contact the troubleshooter to diagnose and operate the press. You notice that the TS tag is removed, what code should you look for to indicate the repair is complete?
17 - Return to Service
What are the top 3 downtime codes that we currently measure? (indicated on WIN card)
1. Return to Service
2. No code entered
3. Membrane change
It is Sunday and you need to perform additional verifications to the presses. Which code should be applied when performing these routine checks?
27 - DOT or Plaquette Change