Show:
Drill Bits
Drills
Types of Holes
Safety Rules
Drill(press) Parts
100

Twist Bit

What is the most common type of drill bit used.

100
Cordless Dirll
What is the most common type of drill seen/used today?
100
Pilot Hole
What is a smaller hole drill into the board prior to a screw being inserted?
100
Clamped
What must be done to the stock prior to drilling.
100
Battery
What powers a cordless drill?
200
Auger Bit
What is the drill bit most used by electricians to drill holes quickly through studs.
200
Drill Press
What is the stationary tool that does the same job as the cordless drill?
200
Through Hole
What is a hole that goes all the way through a board?
200
Cordless/corded drill
What is the only tool that you can start the tool in contact with the wood?
200
Chuck
What holds the bit in the drill/drllpress?
300
Spade Bit
What is the bit which also has the nickname "paddle bit".
300
Cordless Screwdriver
What is the tool that many homeowners keep in a kitchen drawer?
300
Countersink
What is a conical or funnel shaped hole cut into the top of a board to allow the head of a screw to sit flush with the top of the board?
300
Safety Glasses
What must you always wear when using a drill?
300
Clutch
What disengages the motor from the chuck.
400
Hole Saw
What is the tool used mostly by plumbers?
400
Impact Driver
What is the tool that makes driving screws and lag bolts easier?
400
Non-through Hole
What is a hole that is drilled into a board but does not go all the way through?
400
Hair
What you must pull back/tie up before using the drill press.
400
Depth Adjustment Lock
What is used to set the depth on the drillpress?
500
Forstner Bit
What is the bit that drills a flat bottemed hole?
500
Hammer Drill
What is the tool used to drill in concrete/masonery that has a hammering action?
500
Counter-bore
What is a hole which has a flat bottem that allows a screw or bolt to sit below the surface of the wood?
500
Left
Which side should your material being hanging off of the drill press table.
500
Throat
What is the part of the drillpress which determines how far done the chuck can move?