Who is required to report a hazard
Employee
You must be clean shaven when wearing this equipment
What are respirators
A joint health and safety committee is a group of __________ and ______________ representatives working together to identify and solve health and safety problems
What is workers and employer
A worker must complete the following before starting work.
What is Health and Safety Orientation
What is Safe Job Procedure (Blade Installation Section 4.3)
take every reasonable precaution to ensure H&S of their employees
Who is the employer
The responsibility to provide, replace and enforce the use of PPE to the employees under their direction
Who are supervisors
What is once a month
What is a hazard assessment
There is a potential for serious injury when using wither chain saws or brush saws both the operator and employees working in proximity
What is Safe Work Procedure (Chain, Clear and Pole Saw Use, Section 3.2)
Comply with the Acts, the regulations and any order made in Accordance with the Act and regulations
Who is everyone
Boots must have an appropriate tread/grip and boots must have laces and be laced to the top to provide adequate ankle support and required which symbol to be on the boot
What is the green CSA triangle & Orange Omega triangle
Name one of their roles on this committee
What is, promote, inspect, review, advise, recommend
All injuries, incidents, and near misses (not matter how slight) must be _______________ to your immediate supervisor
What is reported
This is put in place to guide the employee performing winter maintenance activities to provide safe access to and egress from the parking lots to the office, garage, etc.
What is Safe Work practice (Winter Maintenance of Parking Areas and Walkways, Section 3.5)
Responsible to inform their employees on all applicable Acts and Regulation and to ensure that these are followed
Who are the supervisors
What is a max of $425
Name a safety representative or JHSC member
Who is
Who are supervisors
The procedure in place if a DTI Vehicle needs to _______ another DTI vehicle.
What is Safe Job Procedure (DTI Plow Truck Recovery Section 4.10)
Take an active role in the workplace health and safety by reporting hazards, incidents, accidents, injury or near miss related to the workplace
Who are employees
What are Hard Hat, High visibility vests, Safety Boots and Safety Glasses.
Employees have access to view the JHSC monthly minutes where
What is the safety board
All assigned _________________ must be worn properly, maintained in good condition, and inspected regularly for defects
What is PPE
This discusses the installation of the Wing Block
What is Safe Job Procedure (Wing Block Installation, Section 4.12)