General Safety
This group must report unsafe conditions, hazards, or defective equipment to their supervisor.
What are workers?
This person must be on-site if required by the traffic control plan.
Who is the Traffic Control Person (TCP)?
This type of label is required on all hazardous product containers in the workplace.
What is a workplace label?
This is utilized each day before commencing work. It must be completed on site to identify and capture all hazards associated with the activities that are performed each shift.
What is a Pre-Job Assessment Form?
This word is represented by the acronym PASS and refers to what you should do after pulling the pin.
What is Aim?
This document outlines Senior Management's commitment to providing a safe and healthy work environment for all employees and all who are involved in our projects.
What is the Health & Safety Policy?
This is the direction you should always begin placing traffic control devices in a work zone.
What is upstream?
This document provides detailed safety information about a hazardous product, including first aid and handling procedures.
What is a Safety Data Sheet (SDS)?
These documents are used as a training aid to provide workers with written sets of instruction for safe performance of a task.
What is a Safe Work Practice (SWP) and Safe Job Procedures (SJP)?
This class of fire involves ordinary combustibles like wood, paper, or cloth.
What is a Class A fire?
These regular checks help spot unsafe conditions, verify procedures are being followed, and prevent accidents before they happen.
What are safety inspections?
These traffic control devices should only be used for short-term daytime work and are not preferred for longer durations.
What are cones?
This group of WHMIS pictograms is used for products that can cause fire or explosion.
What are flame and exploding bomb pictograms?
These forms ensure that tools, equipment, and vehicles are kept in a safe and useable condition. This will limit the potential for maintenance related incidents, limit downtime, and extend productivity.
What are Pre-Use Inspections?
This type of fire extinguisher is best for use on electrical equipment fires.
What is a Class C extinguisher (or CO₂ extinguisher)?
The legislation that governs workplace health and safety.
What is the Occupational Health and Safety Act?
You must do this before removing any traffic control devices at the end of the job.
What is drive through the work zone to ensure it is clear and safe?
This is the maximum number of sections in a WHMIS 2015-compliant Safety Data Sheet.
What is 16?
This is used to notify the appropriate person of the problem and repair of a defective/ overdue tool, equipment or vehicle.
What is a Repair Tag/ Danger Tag?
This should always be your first action before trying to fight a fire with an extinguisher.
What is activate the fire alarm or call for help?
The three basic rights of workers under Occupational Health and Safety laws.
What are the right to know, the right to participate, and the right to refuse unsafe work?
When must traffic control equipment be inspected to verify correct placement and compliance with safety protocols.
What is before and after every shift?
This class of hazard includes products that may cause skin irritation, respiratory issues, or reproductive toxicity.
What are health hazards?
This form is used when there has been an accident/ incident?
What is an incident investigation form?
These are the four steps in the PASS method of using a fire extinguisher.
What are Pull, Aim, Squeeze, and Sweep?