Wood Working
Which sandpaper has the finer grit? 120 or 220?
220 is finer than 120.
A soldering iron is used to weld two wires together. True or False.
False. It is used to SOLDER them together.
The thin layer left behind on top of the weld after making a stick weld with 6013 is called...
Slag
This organization is responsible for setting safety standards...
OSHA
8/16" reduces to...
1/2"
Which saw has a long thin blade that rotates on 2 pulleys?
Bandsaw
Before you solder a joint, you should get the tip of soldering iron covered in a thin shiny layer of solder. This is called...
Tinning
The type of welding hood that allows you to see through the lens while not welding, but DARKENS when you begin to weld is called...
An auto-darkening hood.
When working in a shop environment it is important to remove any __________ from your fingers, wrists, or neck.
Jewlery
Which is a smaller unit of measure, 1/16" or 1/32"
1/32"
Which of these woods is NOT a hardwood... Cherry, Oak, Maple, or Pine.
Pine
The rubber tube that covers a joint and protects the joint from corrosion after it has been soldered is called...
**Clue- it closes around the joint with the use of a heat gun.
Heat Shrink.
The Tensile strength of 7018 is...
70,000lbs
When using a routing table you should always feed your workpiece from _______ to ________.
Right to left.
1/2" + 3/4" = ?
1 1/4"
A table saw is primarily used for long straight cuts that go with the grain. This type of cut is called.....
Rip Cut.
The stand with alligator clips that HELPS hold the wires while you solder them is called....
Helping hands
It is an all position rod
When making a miter cut on the miter saw you should ALWAYS make sure your work piece is.....
Up against the fence, and clamped down.
The top number of a fraction is called the _____________. The bottom number is called a ________________.
Numerator and Denominator
The space left behind by the saw blade that is precisely the width of the blade is called....
Kerf.
Rosin CORE solder has a core made up of...
FLUX
Which current or currents can 6013 be welded with?
A/C and D/C
You should never start a saw blade when it is___________ the workpiece.
Touching
5/8" + 5/8" = ?
10/8" or 1 1/4"