Bending 1
WHAT DOES THE LETTERS EMT STAND FOR?
Electrical Metallic Tubing
A 1 AND 1⁄4" EMT BENDER WILL ALSO BEND _______________RMC
1"
. WHAT IS THE TAKE UP ON A 1/2" EMT STUB 90?
5"
A 1/2" RMC BENDER WILL ALSO BEND_______________EMT
3/4"
WHAT IS THE TAKE UP ON A 1" EMT STUB 90?
8"
WHERE SHOULD I MAKE MY FIRST MARK IN A PIECE OF 3/4" EMT IF I WANT A 16" STUB UP
10"
WHAT DOES THE LETTERS IMC STAND FOR?_
Intermediate Metallic Conduit
A TYPE OF BENDER THAT MAKES SEGMENT BENDS IN SMALL INCREMENTS
Hickey Bender
WHERE SHOULD I MAKE MY FIRST MARK IN A PIECE OF 3/4" EMT IF I WANT A 9" STUB UP
3"
TWO 90 DEGREE BENDS INTHE SAME PIECE OF PIPE ARE REQUIRED FOR A __________BEND?
Back To Back
THE FIRST THING I SHOULD DO AFTER I CUT A PIECE OF PIPE IS...
Ream it
WHEN I BEND A BACK TO BACK 90, DO I BEND THE SECOND 90 TOWARD THE EXISTING 90 OR AWAY FROM THE EXISTING 90
TOWARD
WHAT IS THE TAKE UP ON A 3/4" EMT STUB 90?_
6"
A bend made to change the direction of the conduit.
A Kick
A 3/4" EMT BENDER WILL ALSO BEND________________RMC
1/2"
RMC, IMC AND EMT ARE SOLD IN _________FOOT SECTIONS.
10'
WHERE SHOULD I MAKE MY FIRST MARK IN A PIECE OF 1/2" EMT IF I WANT A 13" STUB UP
8"
WHERE SHOULD I MAKE MY FIRST MARK IN A PIECE OF 1" EMT IF I WANT A 20" STUB UP
12"
WHAT DOES THE LETTERS RMC STAND FOR?_
Rigid Metallic Conduit
Two equal bends made to avoid an obstruction blocking the run of the conduit.
An Offset
A 3/4" RMC BENDER WILL ALSO BEND_______________EMT
1"
A 1" EMT BENDER WILL ALSO BEND_______________RMC
3/4"
TO BEND AN 18" STUB UP, HOW FAR FROM THE END OF THE PIPE SHOULD I MAKE MY MARK IN A PIECE OF 1⁄2" EMT?
13"
WHAT ARE THE FIVE DEGREE MARKS ON A HAND BENDER?
10, 22, 30, 45, and 60 degrees
WHAT IS THE TAKE UP ON A 1 AND 1⁄4" EMT STUB 90?
11"